1) interference wear
干涉磨损
2) Backing off grinding interference
铲磨干涉
3) dry wear
干磨损
1.
The microstructures of those wear surface and wear subsurface being detected and analyzed by SEM、EDS、TEM、XRD,it was found that:the changes of microstructure of these coatings during the dry wear course came of the energy of lattice distortion and stain due to W s.
采用激光熔覆在45钢表面制备微/纳米WC增强Ni基合金涂层,获得不同W过饱和度的涂层组织,并进行相同载荷和不同距离下的干磨损试验,对磨损面及其亚表面的组织结构采用SEM、EDS、TEM和XRD等技术进行分析,发现激光熔覆涂层在干磨损条件下的组织变化主要源于W过饱和引起的晶格畸变能和急冷所致应变能,摩擦表面在摩擦力作用下弥散析出大量纳米级WC颗粒;摩擦亚表层则为摩擦热作用区,通过W扩散脱溶生成WC类相和组织形态变化,释放晶格畸变能和组织应变能,当这些转变结束后,涂层组织就处于一种相对稳定的状态。
4) dry sliding wear
干滑动磨损
1.
Dry Sliding Wear Property of V-EPC Cast-infiltration Composite Layer on the Surface of Cast Steel;
铸钢表面消失模铸渗层干滑动磨损行为研究
2.
Its microstructure, structure of reinforced phase, composition, microhardness and dry sliding wear resistance were studied.
采用消失模铸渗工艺在ZG310-570表面制备了钒铬表面复合层,并考察了其显微组织、增强相的结构、基体组织构成、显微硬度以及干滑动磨损性能。
3.
The dry sliding wear behaviour of the silumin and its composites were investigated.
探讨了高硅铝合金及其原位复合材料的干滑动磨损行为,并对其磨损表面和亚表面形貌进行了观察和分析。
5) dry sliding wear
干摩擦磨损
1.
Wear properties of FeNiMoCuCr series powder sintered steel quenched by surface high frequency were investigated on pin-on-disc wear tester under dry sliding wear condition.
采用销盘式磨损试验机研究了FeN iMoCuCr系粉末烧结钢经表面高频淬火后,在干摩擦磨损条件下的磨损性能,并借助于扫描电镜观察和分析了磨损形貌,探讨其摩擦磨损机制。
6) dry friction and wear
干摩擦磨损
1.
Effect of 3D-meshy SiC on the dry friction and wear of aluminum alloys;
三维网络SiC对铝合金干摩擦磨损性能的影响
补充资料：绝对可磨度(见矿石可磨度)
绝对可磨度(见矿石可磨度)
absolute grindability
Juedu一kemodu--一’一一一z，1」一二一」_L:1;十、、口犷绝对可磨度(absolute gr‘ndab‘l‘ty，兄刁石可磨度。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条