1) dry sliding friction and wear
干滑动摩擦磨损
1.
The dry sliding friction and wear behavior of the aluminum alloy and its composites were investigated.
利用预制体挤压浸渗法分别制备了Al_2O_3或C短纤维单一增强以及两者混杂增强ZL109金属基复合材料,探讨了基体合金及其复合材料的干滑动摩擦磨损行为,并对其磨损表面及亚表面形貌进行了观察和分析。
3) sliding wear
滑动摩擦磨损
1.
The sliding wear experiment of Ni45-15%Mo coating was carried out for comparing with the 38CrMoAl nitriding layer.
采用内孔等离子喷涂技术在内径φ150mm的发动机气缸套内表面38CrMoAl基体上,在开放条件下制备Ni45–15%Mo涂层,并与缸套内表面渗氮硬层,在边界润滑条件下进行了环块滑动摩擦磨损对比试验。
2.
It has been tested that steel-steel rubbing pairs underwent sliding wear processes without lubrication under the condition of static load with accompanying cyclic impacting load together.
本文在恒定载荷伴有周期性冲击载荷条件下对钢-钢摩擦副进行了无润滑的滑动摩擦磨损试验,探讨了附加的周期性冲击载荷对摩擦磨损性能的影响;并依据试验结果,利用磨损形貌特点初步分析了附加的周期性冲击载荷影响钢-钢摩擦副的滑动摩擦磨损行为的原因。
5) dry sliding wear
干摩擦磨损
1.
Wear properties of FeNiMoCuCr series powder sintered steel quenched by surface high frequency were investigated on pin-on-disc wear tester under dry sliding wear condition.
采用销盘式磨损试验机研究了FeN iMoCuCr系粉末烧结钢经表面高频淬火后,在干摩擦磨损条件下的磨损性能,并借助于扫描电镜观察和分析了磨损形貌,探讨其摩擦磨损机制。
6) dry friction and wear
干摩擦磨损
1.
Effect of 3D-meshy SiC on the dry friction and wear of aluminum alloys;
三维网络SiC对铝合金干摩擦磨损性能的影响
补充资料：滑动摩擦
相互接触的物体间发生相对滑动时，在接触面上发生的阻碍相对滑动的现象。滑动摩擦力的大小f跟接触面间的正压力n成正比。f=μn，式中比例系数μ叫做滑动摩擦系数，其值与接触面的材料、粗糙程度、干湿情况以及相对运动的速度等因素有关。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条