说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 界面分散剂
1)  interfacial spreading agent
界面分散剂
2)  surfactant dispersant
界面活性分散剂
1.
Exploitation of surfactant dispersant for water-borne coatings;
水性涂料界面活性分散剂的开发
3)  surface dispersant
表面分散剂
1.
Influence of three kinds of surface dispersants on the activity and heat resistance of Ru/AC catalyst for ammonia synthesis;
3种表面分散剂对Ru/AC氨合成催化剂的活性和耐热性的影响
2.
The Ru /AC catalysts for ammonia synthesis were prepared by the surface dispersant in the impregnation solution which contains ruthenium salt.
采用表面分散剂处理Ru/AC氨合成催化剂的钌盐浸渍液,研究了表面分散剂对钌催化剂活性、分散度及耐热性的影响,结果表明合适的表面分散剂能有效提高钌催化剂的Ru金属分散度从而提高催化性能。
4)  single unit bonding-agent
单组分界面剂
1.
Through the orthogonal experiment,the shear-resistant bond strength with the single unit bonding-agent in the XPS system was analyzed under the normal conditions of 14 days,and the best brushing time for the different surface bonding-agents of polystyrene foam plastics boards was discovered.
对采用单组分界面剂的XPS外保温系统在正常养护14天条件下,进行了拉伸黏结强度正交实验及分析,研究了各种挤塑板界面剂的最佳涂刷时间,并测定了耐水、抗冻融循环及耐热化拉伸黏结强度,力争研究出耐久性好、不空鼓、黏结力高的界面剂,以确保XPS外保温系统达到经济、合理、安全、可靠和耐久。
5)  interface diffusion
界面扩散
1.
The antiferromagnetic coupling and interface diffusion in Fe/Si multilayers;
Fe/Si多层膜的层间耦合与界面扩散
2.
In order to clarify the scale-dependent interface diffusion behavior,the resistivity (ρ) and the specular reflection coefficient (P) of Ni/Al nanomultilayers deposited by magnetron sputtering as a function of the periodic number (n),Ni/Al modulated ratio (R) and modulated period (L) have been characterized by Fuchs-Sondheimer (FS)-Mayadas-Shatzkes (MS) model.
采用FS-MS模型研究了Ni/Al纳米多层膜的薄膜电阻率ρ及镜面反射系数P随周期数n、Ni/Al调制比R和调制波长L的演变规律,从而表征了多层膜界面扩散行为的尺度依赖性。
6)  interfacial diffusion
界面扩散
1.
Nonlinear Kinetics Theory for Interfacial Diffusion in Nanometer-scale Multilayers;
纳米多层薄膜界面扩散的非线性动力学理论研究
2.
The plate model and tube model for analyzing the interfacial diffusion were proposed and the plate model was adopted to test the diffusion.
采用Ni-Fe-C填充材料对WC-30Co硬质合金与45钢的钨极氩弧(TIG)焊进行了研究,观察分析了焊接接头的组织形貌,提出了块体界面扩散的板片模型和管道模型,并采用板片模型对WC-30Co硬质合金与钢TIG焊焊接的WC-30Co/焊缝界面的各元素的扩散行为进行了分析。
3.
The fundamental of electromigration,the phenomenon of electromigration failure,the failure mechanism,the micro-effects and the dominant failure mechanism-interfacial diffusion are introduced.
论述了近年来铜互连电迁移可靠性的研究进展,讨论了电迁移的基本原理、失效现象及其相关机制和微效应以及主导失效的机制——界面扩散等,同时探讨了改善铜互连电迁移性能的各种方法,主要有铜合金、增加金属覆盖层及等离子体表面处理等方法,并指出了Cu互连电迁移可靠性研究有待解决的问题。
补充资料:表面活性剂界面吸附
分子式:
CAS号:

性质:又称表面活性剂界面现象。表面活性剂在液气、液液、液固的界面是以定向正吸附存在,随着表面活性剂在溶液中浓度的增大,表面活性剂在界面的定向吸附从疏散状态逐渐转变为饱和紧密状态,形成界面(表面)之间最低界面(表面)张力,导致各种界面现象,如润湿、乳化、分散、悬浮、发泡、界面电荷等。吉布斯(Gibbs)公式是计算液气、液液的表面或界面吸附定量公式。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条