1) percent consolidation
压密度
2) green density
压坯密度
1.
Warm compaction behavior of 316L stainless steel was investigated, influences of processing parameters of warm compaction on green density of 316L stainless steel were studied.
研究316L不锈钢的温压行为,分析温压工艺参数对压坯密度的影响。
2.
It is found that the green density and sintered density of YBa_2Cu_3O_(7-δ) powders with different granularity varied differently with the variation of pressure.
结果表明,不同粒度YBaCuO超导粉体的压坯密度、烧结密度(即烧结前后的致密度)随压力的变化规律不同。
3.
Influences of processing parameters of warm compaction on green density of 420 stainless steel were studied.
对420不锈钢粉末进行温压,探索温压工艺参数对压坯密度的影响,并对温压与室温模压(添加0。
3) compact density
压坯密度
1.
The effect of compact density on combustion synthesis of Fe-V-C mixture powders based in electric field was studied using Gleeble thermal simulation equipment.
采用Gleeble热模拟机,在电场和大热流密度作用下,研究压坯密度对Fe-V-C三元系粉末压坯燃烧合成的影响。
2.
Using Gleeble-1500D thermal simulation equipment, the effect of compact density on the low temperature combustion synthesis process of the compact of 55wt%(Ti+C)-45wt%Fe mixture powders was studied.
采用Gleeble-1500D 热模拟机,在电场和大热流密度作用下,研究压坯密度对55%(Ti+C)-45%Fe(质量分数)粉末压坯低温燃烧合成过程的影响。
3.
The paper analyzed the effect of sintering temperature,ball milling method and compact density on the density of MoSi2 disperslion-strengthened copper alloy.
分析了烧结温度、球磨方式和压坯密度对MoSi2弥散强化铜合金烧结密度的影响。
4) compaction density
压实密度
1.
By actual examples,the article introduces a new technology in situ measurement of the roadbed compaction density--the additional mass method,and introduces in detail its theory,method and technology,instruments and equipment and its testing results.
通过实例 ,介绍了一种路基压实密度原位测试新技术———附加质量法 ,并对其原理、方法技术、使用仪器设备及试验结果进行了详细叙述 ,最后认为该方法技术值得大力推广应用。
5) compact density
压实密度
1.
Study on the relationship between compact density and compaction energy of CuCr alloys by explosive compaction;
爆炸压实CuCr合金的压实能与压实密度关系的研究
2.
Through analysis on the construction technics and equipment capability of asphalt pavement , the paper points out the respective deviation reasons between the design homogeneity and actual homogeneity of aggregate,temperature and compact density in the asphalt pavement construction.
通过对沥青路面施工工艺各环节和施工设备性能的分析,发现了混合料和铺层的集料均匀性、温度均匀性、压实密度均匀性偏离原混合料设计目标的原因与规律。
6) compacted density
压实密度
1.
The experimental results indicate that compacted MSW is a typical heterogeneous porous media and the average air permeability in the horizontal direction ( \-h) is 7 5—20 0 times of that in the vertical direction compacted direction ( v); Air permeability decline with the increase of compacted density exponentiall.
通过对模拟填埋垃圾体压实方向和与其垂直方向上气体渗透系数的测定 ,研究了在不同压实密度、不同含水率条件下垃圾体渗透特性的变化情况 ,实验表明 :( 1)在垂直压实的填埋垃圾体中 ,水平方向渗透系数平均值 Kh 为垂直方向渗透系数 Kv 的 7 5～ 2 0 0倍 ,填埋垃圾体各向异性特征明显 ;( 2 )垃圾体渗透系数与压实密度、含水率的关系分别满足指数和线性递减规律 ,表明压实密度对渗透系数的影响较含水率大得多 。
2.
The results indicate that gas permeability Kh,Kv decline with compacted density increment in exponential relation for all three decomposing stage MSW and decline with water conten.
通过对不同降解阶段填埋垃圾体渗透系数的测定,研究了在不同压实密度、不同含水率条件下垃圾体渗透特性的变化情况,实验表明:1 对不同降解阶段的填埋垃圾体,新鲜垃圾与混和垃圾的渗透系数接近,腐熟垃圾明显高于前两者;随压实密度增加,其气体渗透系数均呈指数规律递减;2 随着垃圾体含水率的增加,腐熟与新鲜垃圾的渗透系数均呈线性规律递减,含水率对渗透系数的影响要远小于压实密度的影响;3 新鲜垃圾、混合垃圾、腐熟垃圾均具有较显著的各向异性特征,在典型压实密度下,水平方向的气体渗透系数Kh为垂直方向渗透系数Kv的3。
3.
The results showed that the value of the compacted density was a key factor for electrochemical properties of the microencapsulated natural graphite.
研究结果表明,极片的压实密度严重影响改性石墨粒子在极片中的电化学性能,过高的压实密度会导致材料的首次放电效率和循环性能变差。
补充资料：压密
分子式：
CAS号：
性质：粉体层或凝集体受外压时体积减小的现象。当粉体层内充满液体时外力和层的变形是成比例的；描述这一现象的数学关系式，叫压密方程，它是土质力学的基本方程。空隙被水充满的粉体层，若进行压密时会引起脱水，因而压密理论作为压缩脱水的理论基础是很有用的。
CAS号：
性质：粉体层或凝集体受外压时体积减小的现象。当粉体层内充满液体时外力和层的变形是成比例的；描述这一现象的数学关系式，叫压密方程，它是土质力学的基本方程。空隙被水充满的粉体层，若进行压密时会引起脱水，因而压密理论作为压缩脱水的理论基础是很有用的。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条