1)  oil-towater heat exchanger
油-水热交换器
2)  oils
1.
The micro-scale thermo-gravimetric results show that pyrolysis kinetics of waste tyres can be regarded as the linear accumulative total of each elastomer (NR, BR or SBR) as well as their process oils, and the range of reaction is from 250℃ to 520℃, which implies that the kinetics is rarely dependent on the heating.
废轮胎热解实际上是其组成胶体NR、BR、SBR和相应操作油的挥发过程,因此,其动力学模拟方法倾向于采用各种胶体成分热解动力学叠加的多组分模型。
2.
In this article,oil based adjuvants including petroleum oils,vegetable oils and their derivatives were introduced:their mode of action,verities and applications in herbicides.
简要介绍了油类助剂包括矿物油、植物油及其衍生物在国外除草剂中的应用。
3)  Younai
油
1.
Correlation Analysis between Younai Yield and Meteorological Factors;
油产量与气象因素相关性的分析
4)  oil
1.
Preparation and characteristics of organmontmorillonite and adsorption of oily wastewater from port;
有机膨润土的制备与表征及吸附港口含油废水性能
2.
Current Situations and Developments of Determination Method of Micro-amounts Oil in Compressed Air;
压缩空气中微量油测定方法的现状与进展
3.
Infrared spectrophotometric determination of oil in coking wastewater;
红外分光光度法测定焦化废水中油
5)  heavy oil reservoir
稠油油藏
1.
The essential technology of steam drive for heterogeneous heavy oil reservoir with edge-bottom water;
边底水非均质性稠油油藏蒸汽驱关键技术
2.
Secondary recovery of high water-cut conventional heavy oil reservoir;
高含水普通稠油油藏二次开发研究
3.
Secondary development of thick block heavy oil reservoirs in Block Gao246;
高246块厚层块状稠油油藏二次开发研究
6)  Viscous Oil Reservoirs
稠油油藏
1.
Research on Some Flow Characteristics during Water Flooding in Viscous Oil Reservoirs and Improving Development Effects;
稠油油藏注水渗流特性与改善开发效果研究
2.
On Fine Description and Optimal Development of Viscous Oil Reservoirs in Tankou Oilfield;
潭口油田稠油油藏精细描述与优化开发研究
3.
On Applying Oil in Water Emulsion to Improve Water Flood Effects of Viscous Oil Reservoirs;
应用水包油乳状液改善稠油油藏水驱效果研究
参考词条
补充资料:板翅式热交换器(platewingheatexchanger)
板翅式热交换器(platewingheatexchanger)

铝制板翅式热交换器是在数层平金属板之间紧密地放置波纹状的金属导热翅片,并在每一层的四周加上封条,于温度近600℃的盐溶液炉中整体铅焊而成。翅片的主要作用是强化传热,也有增强两金属板强度的作用,在这种热交换器中相邻两通道之间的热交换,一部分通过平板传递热量,但绝大部分热量是通过波纹翅中传递的,因为平板之间均有波纹翅片,因而大大增加了传热面积,所以它的单位体积内的传热面积比一般管式热交换器大10倍以上,达到4000~5000m2/m3。通过各通道之间的不同组合,可得到逆流、错流等形式的热交换器。它具有单位体积传热面积大、传热效率高、流体阻力小、热容量小、结构紧凑及同时允许几种介质进行热交换等优点。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。