1) suspended solids load
悬浮固体负荷
2) suspended solid
悬浮固体
1.
Additionally, electric dehydration, oil cut of waste water and suspended solid content were also tested.
考察了辅助剂、破乳剂和聚合物的浓度、温度、矿化度、pH值、剪切强度和其它药剂等对破乳剂与辅助剂构成的复合破乳性能的影响和电脱水试验,测定了污水含油率和悬浮固体含量。
2.
Suspended solid in the Water will affect the normal growth of submerged plants, in turn, submerged plants will affect the concentration of suspended solid and it's settlement in the water.
水中悬浮固体会影响沉水植物正常的生长,沉水植物反过来也会影响水中悬浮固体的浓度和沉降。
3.
In response to the problems existing in internal recycle three-phase fluidized bed,a high-efficient separation biological fluidized reactor (BFR) was designed by coupling the internal recycle fluidized bed with high-efficient dissolved air floatation,and the removal effect on suspended solid was investigated.
针对内循环三相生物流化床存在的问题,设计出了内循环流化床与溶气气浮相耦合的高效分离生物流化复合反应器(BFR),并考察了其对悬浮固体的去除效果。
4) suspended solids
悬浮固体
1.
Determining suspended solids content,SS,in polymer containing oilfield produced water(OFPW) by using the membrane filtration method(MFM) recommended in P R of China s oil/gas Trade Standard SY/T 5329-94 always leads to a prolonged filtration time and abnormal,rather high SS values.
采用石油天然气行业标准推荐的膜滤法测油田含聚采出水中悬浮固体含量时,过滤时间长而测定值偏高。
2.
95% of suspended solids ranging from 30.
05μm的悬浮固体,可截留92。
6) solid load
固体负荷
1.
It is believed that in designing the secondary sedimentation tanks for extended aeration systems, in addition to the calculation on the basis of surface load, the factor of solid load also should be taken into consideration.
就活性污泥法在不同系统中二沉池的设计参数如何取值进行了探讨 ,认为在延时曝气系统的二沉池设计中除了根据表面负荷计算之外 ,还应考虑固体负荷这一因
补充资料：混合液挥发性悬浮固体
分子式：
CAS号：
性质：活性污泥法曝气池内废水与活性污泥混合液中悬浮固体在灼烧温度为550℃时的分馏物。它表明可用于生物氧化时的活性微生物的浓度。MLVSS一般可按MLSS的70％估计。
CAS号：
性质：活性污泥法曝气池内废水与活性污泥混合液中悬浮固体在灼烧温度为550℃时的分馏物。它表明可用于生物氧化时的活性微生物的浓度。MLVSS一般可按MLSS的70％估计。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条