1) grass type lakes
悬浮固体浓度
1.
Analysis of suspended sediment concentration and water depth in grass type lakes by means of remote sensing;
干旱区草型湖泊悬浮固体浓度及水深的遥感与分析
2) solid suspension density
固体悬浮浓度
1.
Measurement of solid suspension density distribution in the furnace of a 75t/h circulating fluidized bed boiler (CFB) with the water cooled square separator was conducted with the probe developed by Tsinghua University.
针对75t/h水冷方型分离器循环流化床锅炉,利用自行设计的测试方法进行了炉内燃烧室不同位置的局部固体悬浮浓度的测量,确定了燃烧室近壁区沿高度方向及截面方向物料浓度分布,分析了测量结果,并根据测量结果,发展了炉内局部物料浓度的计算模型。
3) mixture liquid suspended solid(MLSS)
混合液悬浮固体浓度
1.
3mg/L;mixture liquid suspended solid(MLSS) of 5200~7800 mg/ L,the reactor can effectively remove the pollutants and the average removal rate of COD ?NH3-N was 90.
3 mg/L,反应器中混合液悬浮固体浓度(MLSS)维持在5200~7800 mg/L时,MBR对水中的COD、NH4+-N平均去除率分别为90。
4) Concentrated suspension
浓悬浮体
1.
Concentrated suspension with high solid loading and low viscosity is required during colloidal forming processing.
胶态成型工艺要求制备高固相含量、低粘度的浓悬浮体。
2.
Then by adjusting specific ion concentration constant K to be 52mS·cm-1,a silicon nitride concentrated suspension with solids loading of 58% (in vol.
2mS·cm-1,获得了体积分数为58%且粘度为1Pa·s的Si3N4浓悬浮体。
5) volatile suspended solid concentration
挥发性悬浮固体含量<浓度>
6) equality degree of suspending solid
固体悬浮均匀度
1.
The solid content and equality degree of suspending solid in a gas-liquid-solid three-phase system of low viscosity have been studied for different impeller speed and gas volumes velocity,by using six impellers.
考察了6种搅拌桨型式、转速和通气量对固含率、固体悬浮均匀度的影响,重点研究了气相对主体流场的影响。
补充资料:混合液悬浮固体
分子式:
CAS号:
性质:活性污泥法曝气池内废水与活性污泥混合液中悬浮固体的浓度,以mg/L计。传统活性污泥法曝气池的混合液悬浮固体一般控制在2000~3500mg/L。
CAS号:
性质:活性污泥法曝气池内废水与活性污泥混合液中悬浮固体的浓度,以mg/L计。传统活性污泥法曝气池的混合液悬浮固体一般控制在2000~3500mg/L。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条