2) web weight
纤维网重量
3) fibre density
纤维比重
4) fiber weigh
纤维计重
5) fiber content
纤维掺量
1.
The variation between fiber content and compressive strength,splitting strength were analyzed.
为了研究纤维掺量对沥青混凝土强度的影响,选用5种纤维掺量沥青混凝土的马歇尔试件和圆柱体试件,在MTS810材料试验机上进行劈裂试验和单轴压缩试验,分析了劈裂试验结果和抗压强度随纤维掺量变化的规律。
2.
When the base strength grade is in the range of C30~C50,and thread steel fiber content is 0~1.
5%掺量范围内,对抗压强度的增强作用明显;当基体强度等级达到C60,纤维掺量在0。
3.
The viscoelastic performance was simulated by using four-unit five-parameter model,its parameters were obtained from the data of the test,and a four-unit five-parameter viscoelastic constitutive model with fiber content was set up.
根据粘弹性力学理论,采用"四单元五参数"模型(修正的Bugers模型)模拟纤维沥青混凝土的粘弹性能,其参数值由试验数据的数值拟合获得,提出了计入纤维掺量的"四单元五参数"粘弹性本构模型。
6) Fiber content
纤维含量
1.
The influence of the short fiber content,fiber length and hybrid effect on the tensile,flexual and impact properties are mainly discussed.
本文讨论了模压成型制成的短纤维增强PVC的制备方法和力学性能,主要探讨了纤维含量、纤维长度、混杂纤维效应等对复合材料拉伸、弯曲和冲击性能的影响。
2.
The tensile strength, flexural and impact strength of samples with different fiber contents are investigated by comparing three kinds of composites with fiber contents of 10,20 and 30wt%.
将纤维重量含量分别为 10 %、2 0 %和 30 %的复合材料进行比较 ,分析纤维含量对复合材料拉伸、弯曲和冲击性能的影响 ;将纤维分别切成约 3mm、5mm和 10mm长制成复合材料进行比较 ,分析纤维长度对复合材料拉伸、弯曲和冲击性能的影响。
3.
Wearability of composites with different fiber orientation and different fiber content has been analyzed.
着重研究了纤维取向、纤维含量、外加载荷的变化对复合材料磨损性能的影响、通过对磨痕扫描电镜的观察，探讨了复合材料的磨损机理。
补充资料：碳(石墨)纤维增强体(见碳纤维、石墨纤维)
碳(石墨)纤维增强体(见碳纤维、石墨纤维)
earbon(graPhite)fibrereinforeements
，、、里z耽维增强体earbon(graphi现inforcements用于复合材料中承受负荷，田的磷纤始知五史纤俯亡e)fibre起增强作
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条