1) gathering temperature
挑料温度
2) working-out,temperature
(玻璃的)挑料温度
3) gather
[英]['ɡæðə(r)] [美]['gæðɚ]
挑料
4) feed temperature
进料温度
1.
The effects of the feed composition and the feed temperature on the energy-saving efficiency of the backward-feed two-effect distillation are researched in ethanol-water system by process simulation.
以乙醇-水为物系,通过模拟计算,研究进料组成和进料温度对三种逆流双效精馏节能效果的影响。
2.
As the forward-feed,backward-feed,dual-feed two-effect distillation are not better used at the conditions of the feed temperature being higher than the bubble point temperature,we chose new type distillation flow-two-effects system with vapor feed to reboiler.
由于常见的双效精馏、顺流双效精馏、逆流双效精馏、平流双效精馏在泡点以上温度进料时,节能效果不是很理想,针对泡点以上温度进料,我们研究了新型节能流程——气体进料作再沸器热源双效精馏流程,以乙醇-水为实验物系,通过模拟计算,考察进料组成和进料温度对其节能率的影响。
5) barrel temperature
料筒温度
1.
PID controller of barrel temperature based on BP neural network;
基于BP神经网络的料筒温度PID控制器
2.
Process parameters are settled such as barrel temperature, screw speed, injection pressure, injection velocity and holding time and so on.
介绍了热固性团状模塑料 ( BMC)注射成型汽车前照灯反射镜的工艺过程 ,确定了 BMC注射成型的料筒温度、螺杆转速、注射压力、注射速度和保压时间等工艺参数。
3.
Firstly, this paper analyzes the electronic control system of plastic injection-molding machine in detail, puts forward a method which bases on the control algorithm of PID neural network to regulate the barrel temperature, and uses the method to simulate the model of barrel heating system.
论文在对注塑机电控系统进行详细分析的基础上,提出了利用PID神经元网络控制算法对塑机料筒温度进行控制的方法,并对该方法进行了仿真分析,接着阐述了基于ARM处理器LPC2138的注塑机控制器的软硬件设计,最后对系统的运行调试方法进行了介绍。
6) charge level temperature
料面温度
1.
Firing temperature control system of 90 m 2 sintering machine in Xiangtan Iron and Steel Company was computer automatic control system for charge level temperature.
湘钢二烧 90 m2 烧结机点火温度控制系统采用了计算机自动控制料面温度和空燃比寻优 ,对该系统的结构、控制对象特性、参数计算、控制模型及编程作了简介。
补充资料：挑唇料嘴
1.见"挑牙料唇"。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条