1.
Increasing feed-in temperature can augment the reduction of activities of polyphenoloxidase being treated by IHP.
提高进料温度,可以增强瞬时高压对多酚氧化酶的钝化效果。
2.
However, for certain temperaturesensitive materials the inlet gas temperature must be lowered.
但是，对于某些温度敏感的材料，进入的气体温度必须降低。
3.
maximum assessed fuel element temperature
燃料元件最高设定温度
4.
Plastic mulch increases soil temperature in the bed which promotes faster crop development and earlier yields.
塑料薄膜覆盖提高苗床的土壤温度，促进作物较快发育并提早成熟。
5.
A new technology for improving hot blast temperature and decreasing fuel consumption with high emissivity coating on the regenerator of blast furnace (BF) hot stove were introduced.
介绍一种可以进一步提高热风炉热风温度，降低燃料消耗的新技术。
6.
Experimental Study on Combustion Process of the Homogeneous Charge Compression Ignition Engine Fueled with Ethanol Using Induction Temperature;
进气温度对醇类燃料均质压燃发动机燃烧过程影响的试验研究
7.
Study on Ethanol SI/HCCI Hybrid Combustion Engine with Intake Charge Temperature Control;
基于进气温度控制的乙醇燃料SI/HCCI复合燃烧模式发动机研究
8.
Research progress of effect of temperature on properties of resin-based composites
关于温度对树脂基复合材料性能影响的研究进展
9.
Research Progress of Thermal Analysis Methods for Determining SADT of Energetic Material
热分析法测定含能材料自加速分解温度的研究进展
10.
REVIEW OF THE TEMPERATURE FIELD RESEARCH OF AUTOCLAVE MOULDING FOR ADVANCED COMPOSITE COMPONENTS
热压罐工艺成型先进复合材料构件的温度场研究综述
11.
The paper studies preliminarily waste plastic combustion dynamics by steady temperature and thermal gravimetric experiment of blast furnace blasting temperature.
通过高炉鼓风温度的恒温热重实验,本文对废弃塑料燃烧动力学进行了初步的研究。
12.
The multiwavelength pyrometer with prisms for beam split has been used to measure the true temperature of ablative materials burnt by oxyacetylene flame.
应用棱镜分光式多波长光电高温计对氧乙炔焰烧蚀材料的真实温度进行了测量。
13.
The temperature Control Research of Evotherm Warm-Mix Asphalt
EVOTHERM温拌混合料温度控制研究
14.
The increase in hardness and strength of a ductile metal as it is plastically deformed below its recrystallization temperature.
塑性材料于再结晶温度以下进行塑性变形引起的硬度和强度升高现象。
15.
stage or degree of progress,increase,temperature,etc
（进展、增进等的）阶段,程度;（温度等的）度
16.
Effect of heat treatment temperature on crack-healing and bending strength of SiC/Si_3N_4 composites
愈合温度对SiC/Si_3N_4复合材料强度的影响
17.
Propellant inlet temperature control for cryogenic rocket engine tests
低温发动机试验推进剂入口温度控制
18.
New Developments of High and Superhigh Temperature Gas Filtration Materials Home and Abroad
国内外高温与超高温气体过滤材料新进展