1) karbogel
['kɑ:bəu,dʒel]
碳胶
2) carbon aerogel
碳气凝胶
1.
The microstructure of carbon aerogel was investigated by using electron scanning microscope(SEM),pore size distribution and electrical conductivity measurement.
探索新型纳米多孔材料碳气凝胶的微结构控制,研究常压条件下纤维增强型碳气凝胶的制备,以及催化剂浓度、质量分数、纤维表面特性、溶胶注入纤维前的老化时间等制备参数对其微结构的影响。
2.
This paper examins carbon aerogel by SEM, BET and cyclic voltammetry.
在常压条件下通过溶胶-凝胶法和碳化、活化工艺制备碳气凝胶材料。
3.
The micro structure of the porous carbon aerogels is measured by SEM and BET.
经高温碳化处理 ,将RF有机气凝胶转化为碳气凝胶 ,改变RC比和聚合单体的质量百分数 ,可控制气凝胶的粒径及孔径、密度及比表面积。
3) colloidal carbon spheres
胶体碳球
1.
Preparation of SiO_2,TiO_2,SnO_2 hollow spheres by colloidal carbon spheres;
利用胶体碳球为模板制备SiO_2、TiO_2、SnO_2空心球
2.
The feasibility of most templates were investigated and the colloidal carbon spheres were confirmed as the best one.
研究了多个模板的可行性,确定了最佳模板——胶体碳球。
4) carbon aerogels
碳气凝胶
1.
For the first time,hydroquinone-formaldehyde aerogels have been prepared by sol-gel method and CO_2 supercritical drying,and after high temperature carbonization the carbonized carbon aerogels are obtained.
首次用溶胶-凝胶法和CO2超临界干燥技术制备了对苯二酚-甲醛有机气凝胶,并经高温碳化处理得到其碳气凝胶,测得气凝胶的比表面积由碳化前的375。
2.
In this paper, carbon aerogels are obtained through ordinary pressure drying; their structural properties are investigated.
碳气凝胶是一种新型多孔碳材料,具有比表面积大、电导率高的特点。
3.
SEM, BET and pore size distribution techniques were used to characterize the morphology and pore structure of the carbon aerogels.
研究了碳气凝胶在常压条件下的制备过程和干燥方法。
5) carbonaceous aerosol
碳气溶胶
1.
The physical and chemical characterization of carbonaceous aerosol at the atmospheric background site in Diqing,Yunnan;
云南迪庆地区大气本底碳气溶胶的理化特征
2.
The purpose of this study was to investigate the day-night variation of carbonaceous aerosols in PM_(10) during spring and winter over Xi\'an.
为探讨西安市大气碳气溶胶的季节变化和昼夜变化特征及来源,于2006-12-19~2007-01-21(冬季)和2007-04-01~2007-04-30(春季)连续采集了大气可吸入颗粒物(PM10)样品,并采用IMPROVE热光分析法分析了其中有机碳(OC)和元素碳(EC)的昼夜浓度。
6) carbon-silica gel
碳硅凝胶
1.
Meso-tetrakis(4-aminophenyl)porphyrin[T(4-TAP)P] used as a suitable chelating reagent was loaded on the mixture of active carbon-silica gel.
首次以meso-四(4-氨基苯基)卟啉为衍生化试剂,使其负载于碳硅凝胶填充材料上,在优化的实验条件下,于pH9。
补充资料:碳纤维上胶剂
分子式:
CAS号:
性质:指碳纤维经表面处理后进行的上胶剂处理,又称碳纤维上浆剂。其作用是保护碳纤维表面处理(特别是臭氧处理或等离子体处理)后产生的表面活性,有利于改善与树脂母体的黏合力及后加工性能,防止毛丝的产生。上胶剂的种类有聚酰胺类和环氧树脂类等。以聚α-(N,N-二甲胺)-己内酰胺或其共聚物为例,碳纤维经涂覆该上浆剂后,复合材料强度由未上胶前的16.66GPa提高至23.52GPa。
CAS号:
性质:指碳纤维经表面处理后进行的上胶剂处理,又称碳纤维上浆剂。其作用是保护碳纤维表面处理(特别是臭氧处理或等离子体处理)后产生的表面活性,有利于改善与树脂母体的黏合力及后加工性能,防止毛丝的产生。上胶剂的种类有聚酰胺类和环氧树脂类等。以聚α-(N,N-二甲胺)-己内酰胺或其共聚物为例,碳纤维经涂覆该上浆剂后,复合材料强度由未上胶前的16.66GPa提高至23.52GPa。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条