说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 冷气化效率
1)  cold gasification efficiency
冷气化效率
2)  cold gas efficiency
冷煤气效率
1.
Syngas heating value and cold gas efficiency which are the key parameters to evaluate syngas quality and performance of gasifier influenced the efficiency of whole IGCC power system directly.
合成气化学能和冷煤气效率直接影响着整个IGCC电站系统效率,是衡量合成气品质和气化炉性能的关键参数。
3)  gasification efficiency
气化效率
1.
Based on the influence of cycle period on gasification efficiency and the effect of lag time of programmed control valve, the optimal cycle period has been obtained as 120s.
在计算机上对模型进行数值仿真计算,摸索出循环周期对气化效率的变化规律,结合程序控制阀门滞后时间的影响,得出优化的循环周期为120s。
2.
On the base of principle of general gasification process, the gasification efficiency and thermal efficiency of high temperature air gasification in pebblebed are calculated by synthetic method.
介绍了高温空气卵石床气化器的工作原理,分析了气化的反应机理,采用综合计算法对卵石床气化器的气化效率和热效率进行了计算,以煤的气化为例,计算得出煤气化效率为64。
3.
Using coke not only increases the gasification efficiency by 25 percent and economic benefit by 14 percent but also decreases the operating difficulty and environmental pollution when the production load is seriously insufficient.
对两段炉使用烟煤和焦炭为原料作了经济技术比较 ,在生产负荷严重不足时 ,使用焦炭可以提高气化效率 2 5% ,提高经济效益 14% ,降低操作难度 ,减少环境污
4)  film cooling effectiveness
气膜冷却效率
1.
Experimental investigation on film cooling effectiveness of multi-hole at longitudinal wavy surface
多孔纵向波纹表面气膜冷却效率实验研究
2.
Calculation results show that rotation causes film cooling effectiveness on the pressure surface to drop—the quicker the rotation the low.
采用数值模拟的方法对旋转涡轮叶片表面的气膜冷却效率进行了研究,同时对涡轮静叶栅和动叶片在不同的旋转速度下分别进行计算,分析不同转速、吹风比和冷却气流喷射角度对气膜冷却的影响。
3.
The B-L turbulent model is employed to compute film cooling effectiveness of flat, concave and convex surfaces.
采用B-L紊流模型对平板、凹面和凸面上气膜冷却效率进行了数值模拟,对不同吹风比(0。
5)  Film cooling efficiency
气膜冷却效率
1.
A three-dimensional steady and uncompressible N-S equation was discretized by volume-control method to simulate the effects of hole\'s geometry shapes on film cooling efficiency of turbine blade in combining with non-structural mesh and two-layer k-ε turbulence model,with blowing ratio of 0.
2的情况下,利用非结构化网格及两层k-ε湍流模型,对气膜孔几何形状对涡轮叶片气膜冷却效率的影响进行了数值模拟,得到气膜孔附近的流场分布。
6)  hot gasification efficiency
热气化效率
补充资料:配置效率和生产效率
  在经济学上,经济发展的动力,或者说效率的来源,分为两类:一类是配置效率,二是生产效率。所谓配置效率,是指给定资源和技术的条件下,怎么样使资源从边际生产率低的地方流向边际生产率高的地方,从而使得资源和利用更合理、社会总价值达到最大;而生产效率是指如何通过技术进步提高每一种资源的生产率,也就是把社会的生产可行性边界向外移。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条