1) depth of indentation
刻痕深度
2) deep scoring
深的刻痕
3) carve hardness
刻痕硬度
1.
The element Bi was added to Sn-Zn alloy,the effects of Bi content on melting point,microstructure,wear resistance,contract rate and carve hardness were researched.
在Sn-Zn合金中添加Bi,就Bi含量对低熔点合金的熔点、组织、耐磨性、合金收缩率和刻痕硬度的影响进行了研究。
4) indentation depth
压痕深度
1.
The feasibility of indentation depth measured by servo gun online was studied.
首先研究利用伺服焊枪在线提取压痕深度的可行性。
2.
Meanwhile the material model behavior is established to analyze the indentation depth under the local force, calculate the hardness by the ANSYS.
材料模型属性描述的准确性在ANSYS分析中尤为关键,本文通过实验方法获得了典型材料的力学参数,特别是材料在塑性阶段的应力应变关系,并对实验数据进行了有效的整理,在ANSYS中建立了这些材料的模型属性,分析了在局部载荷下的压痕深度,计算其有限元硬度值,比较实验硬度值和有限元硬度值。
3.
The indentation depth of three-layer parquet surface layer, in the early pressure, is rapid increase in the deepening of the depth indentation.
三层实木复合地板表面层的压痕深度,在加压初期,随加压时间增加而快速加深,当加压时间超过10-15天后,压痕深度的加深十分缓慢甚至停止。
5) cutting mark depth
锯痕深度
1.
Then, factors affetcing cutting mark depth of cutting face are analysed and gives out theoretical calculationformula of different sawblades cutting mark depth.
然后进一步分析了影响锯切表面锯痕深度的有关因素，给出了不同锯的锯痕深度理论值公式及其通式。
6) mud depth
泥痕深度
1.
As an important parameter usually decided by field survey,mud depth of debris flow is directly related to quantitative calculation of velocity and impact forces.
泥石流泥痕深度是一个通过勘测调查获取的重要参数,它直接关系到泥石流运动流速、冲击力等特征参数的定量计算。
补充资料：痕痕
1.犹言一道道。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条