1) bucking strength
浸渍强度;弯曲强度
2) bending strength
弯曲强度
1.
Studies on the Relations of Gear Bending Strength and the Undercutting Thickness;
齿轮弯曲强度与沉切量关系研究
2.
Influence of process on the bending strength of SiC_f/Si-O-C composite;
制备工艺对SiC_f/Si-O-C复合材料弯曲强度的影响
3.
Dynamic elastic modulus-bending strength of cured LPA/UP with acoustical resonance;
声频振动法测定LPA/UP固化物动弹模量-弯曲强度的试验研究
3) Flexural strength
弯曲强度
1.
Influence of γ-ray irradiation APMOC fiber on flexural strength of AFRC;
γ-射线辐照APMOC纤维对AFRC弯曲强度的影响
2.
Statistical significance of flexural strength of IPS-Empress2 glass-ceramics;
IPS-Empress2玻璃陶瓷弯曲强度的测试及意义
3.
The influence of marking technology on the flexural strength of denture bases;
刻痕标记技术对义齿基托塑料弯曲强度的影响
4) bend strength
弯曲强度
1.
The recently-developed PdCo-(4~20)V-4Ni-Si-B brazing foils were used for SiC joining,and the room-temperature three-point bend strengths of the SiC/SiC joints brazed at 1463 K and 1493 K for 10 min are 52.
设计的PdCo-(4~20)V-(2~4)Ni-Si-B钎料可用于SiC的连接,在1463 K,1493 K两个温度,保温时间均为10 min的连接条件下得到的接头室温三点弯曲强度分别为52。
2.
The mechanical models of bend stiffness and bend strength of the pallets girder and deck were established.
通过分析木托盘在均布载荷作用下的受力变形情况,建立了木托盘梁和铺板的弯曲强度和弯曲刚度的力学模型,提出了托盘弯曲强度和刚度的条件。
5) flexure strength
弯曲强度
1.
The fracture toughness and flexure strength from room temperature to 900℃ of zirconium diboride-silicon carbide(ZS) composites and zirconium diboride-silicon carbide with the addition of short carbon fiber(ZSC) were examined and analyzed.
对ZrB2-SiC(ZS)材料和碳短纤维/ZrB2-SiC(ZSC)材料的断裂韧性、室温至900℃弯曲强度进行了测试和研究。
2.
The volume density,open porosities and flexure strength of porous silicon nitride ceramics are measured respectively by Archimedes and three-point bend.
利用阿基米德法、三点弯曲法测试了材料的密度、显气孔率及弯曲强度;借助扫描电子显微镜(SEM)进行微观结构分析。
3.
The effects of temperature on the notch flexure strength of alumina are experimentally investigated.
试验研究了温度对Al2 O3 陶瓷弯曲切口强度的影响 ,结果表明 :在 2 0～ 80 0℃之间 ,材料的弯曲强度和弯曲切口强度不仅没有降低 ,甚至略有升高 ,它们的分散性随着温度的升高而降低 ,但在 95 0℃条件下 ,其弯曲强度和弯曲切口强度均显著降低 。
6) wet flexural strength
湿弯曲强度
补充资料：表光合强度(见光合强度)
表光合强度(见光合强度)
forecast of sowing or transplanting time
b iaoguanghe qiangdu表光合强度见光合强度
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条