2) arcuate fault
弧形断裂
1.
Based on researches on characteristics of the He125 fault,the authors have found that the arcuate fault is parallel to the fault strike and is the combination of fault-trough and fault-ridge,as evidenced from the profile.
通过对河125断层几何学特征的分析发现弧形断裂平行于断层走向剖面上表现为断槽、断脊组合;垂直于断层走向剖面上断层分为竖滑段、倾滑段和平滑段3段,生长指数规律为弧中大于弧翼,断层倾角规律为弧中小于弧翼。
2.
The arcuate fault is the combination of fault trough and fault ridge,it is found from the section that is parallel to the arcuate,the fault can be separately divided into three parts,vertical-slip part,dip-slip part and horizontal-slip part from the section that is perpendicula.
为解释断层下降盘浊积砂体横向不均一的控制机理,从河125断层几何特征入手,剖析了断层形态与浊积砂体的关系,发现弧形断裂平行于断层走向剖面上为断槽、断脊组合;在垂直于断层走向剖面上断层可分为竖滑段、倾滑段和平滑段三段。
3) Circular crack
圆弧裂纹
1.
The interaction between piezoelectric screw dislocation and circular crack under remote uniform heat flux was investigated.
研究压电材料在均匀热流作用下螺型位错与圆弧裂纹的相互作用。
4) crater crack
弧坑裂纹
1.
A great number of T91 steel tubes are applied in 300 MW and 600 MW boiler,but some power plants find crater crack in some of T91 steel tubes in TIG+MIG process, the cause of crater crack is andlized in detail and solution measures are taken in this pape
30 0、60 0MW锅炉中大量使用T91钢管 ,而电厂反映T91钢管的TIG +MIG焊口存在弧坑裂纹。
2.
A great number of SA-213 T91 steel tubes are applied in plant power boiler,but some power plants find crater crack in some of SA-213 T91 steel tubes in TIG+MIG process,the cause of crater crack is andlized in detail and solution measures are taken in this paper.
电站锅炉中大量使用SA-213 T91钢管,而电厂反映SA-213 T91钢管的TIG+MIG焊口存在弧坑裂纹。
5) arcsplitting
弧压劈裂
6) arc crack
弧形裂纹
1.
Dynamic stress concentration of SH-waves by arc cracks near a circular lining;
SH波作用下弧形裂纹对圆形衬砌动应力集中系数的影响
2.
The reason of arc crack on retarder gear surface was analyzed by means of chemical composition analysis,hardness testing,macrostructure and microstructure examination.
通过化学成分分析、硬度试验、宏观和微观检验等方法,对减速机齿轮齿面弧形裂纹的产生原因进行了分析。
补充资料：裂裂
1.象声词。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条