2) back plate
后罩板
1.
Comparison tests are done on a A186F carding machine under such conditions as a back stationary flat system with suction device is equipped on the back plate with the suction on one side and on two sides.
在下列条件下对A186F梳棉机进行了对比试验:梳棉机原有状态不变;梳棉机后罩板加装带有吸风装置的后固定盖板系统,单侧吸风;梳棉机后罩板加装带有吸风装置的后固定盖板系统,双侧吸风。
2.
The result shows that either too large or too small wind′s flow at back plate is unfavorable to card sliver quality,and a wind′s flow about 180～240 m~3/h is advantageous under such conditions.
结果表明,后罩板处棉网清洁器风量太小和太大对生条质量均是不利的,在试验条件下,棉网清洁器的风量在180~240 m3/h时对生条质量的提高比较有利。
3.
Adding a separate web purifier at the back plate of a cotton card is favorable to improving the quality of the sliver and the resulted yarn.
梳棉机后罩板处单独加装棉网清洁器对提高棉条及成纱质量是有利的,风量适宜可起到固定盖板的作用,文章通过试验分析指出,吸风量为240m3/h时,只加装棉网清洁器效果最佳。
3) Back Cover Guard
后罩板
1.
Influence on Yarn Quality of the Cotton Web Cleaner Position in Carding Machine Back Cover Guard;
梳棉机后罩板棉网清洁器位置与纺纱质量
2.
Testing Research on Setting Cotton Web Cleaner in Back Cover Guard of Carding Machine;
梳棉机后罩板处加棉网清洁器的试验研究
4) right_rear wheel hood
右后轮罩
1.
An introduction was made on the design of the essential processing drawing and the part_processing procedure drawing, the selection of the pressing direction, the makeup design of the technological process, and the location of the drawing ribbings in designing the pressing process of the front part of the right_rear wheel hood of Fukang cars.
介绍了富康轿车右后轮罩前部冲压工艺设计中的加工要领图、工序制件图设计及冲压方向选择、工艺补充设计和拉伸筋设置等。
5) rear wheel cover
后轮罩
1.
In this paper, a new griding method is introduced to calculate strain and stress contour for rear wheel cover of CA142 truck and the reasons for stamping defects are analyzed.
本文以ＣＡ１４２汽车后轮罩为对象，利用一种新的网格方法，计算了应变、应力等高线，分析了后轮罩出现冲压缺陷的原因。
补充资料：罩罩
1.鱼游貌。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条