1) low carbon steel can
低碳钢包套
2) low carbon working lining for ladle
低碳钢包工作衬砖
3) low carbon carburizing steel
低碳渗碳钢
4) mild steel
低碳钢
1.
Effect of longitudinal magnetic field on microstructure and properties of MIG weld joint of mild steel;
纵向磁场对低碳钢MIG焊焊缝组织及性能的影响
2.
Study of weldability of activating flux for A-TIG welding of mild steel;
低碳钢A-TIG焊活性剂的焊接性研究
3.
Study activating flux for mild steel;
低碳钢A-TIG焊的活性剂研制
5) Low carbon steel
低碳钢
1.
Dissipative structures of inner cracks in low carbon steel during thermal healing;
低碳钢内裂纹热愈合时的耗散结构
2.
Study on Low Carbon Steel Deoxidized by Magnesium Alloy;
低碳钢镁合金脱氧的研究
3.
Analysis on metallurgical effect of low carbon steel in No.1 top-bottom combined blowing converter in Liangang;
涟钢1号顶底复吹转炉低碳钢冶金效果分析
6) ULC steel
超低碳钢
1.
Study on the optimum process of refining ULC steel by RH degasser
RH冶炼超低碳钢的最优工艺研究
2.
Inclusions and total oxygen content in ultra-low carbon(ULC) steel were studied for the control of cluster inclusions in ULC steel.
为控制超低碳钢中的簇状夹杂物,对超低碳钢中的夹杂物和与全氧含量的关系进行了研究。
3.
The polarization curve of the ULC steel with titanium and niobium was measured to determine the suitable electrolytic parameters for preparation of TEM carbon replica samples.
测定了一种复合添加钛、铌超低碳钢的极化曲线,选用合适的电流密度和电解时间以碳复型方法萃取钢中的析出相制备透射电镜观察用样品。
补充资料：包套挤压
包套挤压
sheath extrusion
bootao」iya包套挤压(sheath extrusion)将液态金属包覆在芯线材料上的挤压方法。此法专用于电缆包套，因此也称为电缆包套挤压，有铅包套电缆挤压和铝包套电缆挤压两种。工艺过程是:将熔化了的铅或铝注人立式挤压筒中，挤压杆对筒内液态金属施加轻微压力，待金属凝固至适当温度时以二股金属流入挤压筒下部的空腔中，包在水平方向引入的芯线材料上面，并同芯线焊合起来一齐从模孔挤出，形成壁厚均匀、连续、完整的包套(见图)。包套的厚度主要靠调整模子与芯统材料的相对位置来控制。粤 电缆包套挤压示意图 最初的包套材料为铅，由于其强度差、密度大，已被密度小、抗腐蚀、塑性好、有足够强度的铝所取代。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条