1) air blown poke nole
吹气拨火孔
2) gas blowing
吹气
1.
Water modeling on gas blowing in tundish;
中间包吹气的水力学研究
2.
Simulation study of slab continuous casting tundish with bottom gas blowing;
板坯连铸中间包底吹气数值模拟研究
3.
Effect on steel liquid flow in the bottom gas blowing tundish of different porous materials was studied using water modeling.
采用不同性能参数的多孔透气砖进行中间包底部吹气水模实验,研究透气砖的气孔率、透气度、平均孔径对所形成的气泡大小和能形成有效气幕所需条件的影响,并分析使用不同透气砖时的RTD曲线,对使用不同透气砖时的吹气参数进行了优化。
3) blowing
吹气
1.
Effects of jet blowing on the side force of forebodies with different cross section;
不同截面机身头部吹气方式对侧向力的影响
2.
Under the same reheating conditions, the influence of time sequence of stretch and blowing (characterized with delay time t0) on the preform growth in stretch blow molding (SBM) was studied using a transparent mold and a digital camcorder.
在型坯再加热条件不变的情况下,通过全透明模具和数码摄像机研究了两步法拉伸吹塑中拉伸与吹气的时序(即预吹气延迟时间t0)对型坯拉伸吹胀模式的影响。
3.
A flow visualization investigation on leading edge breakdown is conducted in a wind tunnel to identify the effect of blowing on a strake wing model undergoing large amplitude pitching motions.
实验采用翼面吹气控制翼面非定常流动，通过烟流显示涡轨迹和涡破碎位置，用相锁照相技术记录空间流态。
4) lateral gas flow
侧吹气流
5) side blowing
侧向吹气
1.
The methods to dress diamond grinding wheel using assistant side blowing and to measure grinding force with simplifying process were presented,in which grinding force,grinding force ratio and specific grinding energy were computed and the comparison between the results before and after laser dressing verified the effectiveness of laser dressing from different aspects.
介绍了辅助侧向吹气法金属结合剂金刚石砂轮的激光修锐试验和简化测力评价方法,计算比较了修锐前后砂轮磨削力、磨削力比和比磨削能,从不同角度说明了辅助侧向吹气法对激光修锐金属结合剂金刚石砂轮的有效性。
6) side assist gas
侧吹气体
参考词条
补充资料：拨火
1.拨旺炉火。引申为挑拨﹐煽动。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。