1) Purging hole
吹气口
2) nozzle injection
水口吹气
4) multi slot blowing
多喷口吹气
1.
This paper studies the control of the circulation around a circular cylinder with multi slot blowing, using the method of Navier Stokes equation simulation.
对用壁面射流控制圆柱绕流的问题进行了研究，并探讨了喷口位置、多喷口吹气等问题。
5) gas blowing
吹气
1.
Water modeling on gas blowing in tundish;
中间包吹气的水力学研究
2.
Simulation study of slab continuous casting tundish with bottom gas blowing;
板坯连铸中间包底吹气数值模拟研究
3.
Effect on steel liquid flow in the bottom gas blowing tundish of different porous materials was studied using water modeling.
采用不同性能参数的多孔透气砖进行中间包底部吹气水模实验,研究透气砖的气孔率、透气度、平均孔径对所形成的气泡大小和能形成有效气幕所需条件的影响,并分析使用不同透气砖时的RTD曲线,对使用不同透气砖时的吹气参数进行了优化。
6) blowing
[英]['bləuiŋ] [美]['bloɪŋ]
吹气
1.
Effects of jet blowing on the side force of forebodies with different cross section;
不同截面机身头部吹气方式对侧向力的影响
2.
Under the same reheating conditions, the influence of time sequence of stretch and blowing (characterized with delay time t0) on the preform growth in stretch blow molding (SBM) was studied using a transparent mold and a digital camcorder.
在型坯再加热条件不变的情况下,通过全透明模具和数码摄像机研究了两步法拉伸吹塑中拉伸与吹气的时序(即预吹气延迟时间t0)对型坯拉伸吹胀模式的影响。
3.
A flow visualization investigation on leading edge breakdown is conducted in a wind tunnel to identify the effect of blowing on a strake wing model undergoing large amplitude pitching motions.
实验采用翼面吹气控制翼面非定常流动，通过烟流显示涡轨迹和涡破碎位置，用相锁照相技术记录空间流态。
补充资料：气口
气口 气口 人体部位名。即寸口。《素问·经脉别论》：“气口成寸，以决死生。”详该条。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条