1) sweep gas
穿透气
2) gas penetration
气体穿透
1.
Meshless analysis on primary gas penetration during gas-assisted injection molding;
气辅成型首次气体穿透的无网格模拟
2.
Effect of gas penetration on the design of gas passage of gas assistant molding;
气辅成型中气道设计对气体穿透的影响
3.
Experimental study on gas penetration and RWT in GAIM;
气辅成型过程气体穿透长度与残余壁厚的试验研究
3) Bubble penetration
气泡穿透
4) plume penetration
烟气穿透
5) gas penetration ratio
气体穿透率
1.
In this paper,based on GAIM parts with semicircle rib,the orthogonal experimental design and interaction figures are used to find out the influence of interaction parameters on gas penetration ratios and gas "fingering".
针对以往有关工艺参数间的交互作用对注塑制品质量影响的研究较少的现象,以气体辅助注射成型某半圆形加强筋截面制品为例,运用正交试验和交互作用图筛选出影响气体穿透率和气指效应程度的交互影响因素,并基于交互效应值得出影响气体穿透率的最主要的交互因素是熔体温度和延迟时间,影响气指效应程度的最主要因素是熔体温度和注气压力,最后结合单因素试验对相应指标进行了分析。
6) hot-air through
热气流穿透
1.
There were definite researches on bonding thermal analysis and stream guidance of hot-air through bonded diaper nonwovens(HTBDN) at home,and it was scarce that research bicomponent fibers\' bonding thermal analysis in the view of fluid mechanics and heat transmission.
热气流穿透粘合非织造尿布材料(以下简称热风非织造材料)作为人们日常生活的必需品,其应用日益广泛。
补充资料：采气工艺(见天然气开采工艺)
采气工艺(见天然气开采工艺)
gas production technology
，一‘J\匕乙吕天然气开采工艺pro以uetionteehnology)见
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条