1)  impression resin,conduct resin,contact resin
触压树脂
2)  contact pressure
接触压力
1.
Calculation of contact pressure on TM and VAMACE premium connection casing couplings;
TM和VAMACE特殊螺纹套管接箍接触压力计算
2.
The effect of articular step-off and neniscectomy on joint alignment and contact pressures for fractures of the lateral tibial plateau;
胫骨外侧髁骨折塌陷对关节轴线及接触压力的影响
3.
Single chip microcomputer-based inspection of catenaries-pantograph contact pressure;
基于单片机的弓网接触压力检测
3)  contacting pressure
接触压力
1.
Research on contacting pressure in ball-spinning;
滚珠旋压工艺中成形区接触压力的分析计算
2.
A pin-on-disk test rig was used to investigate the influence of sliding speed and contacting pressure on the friction and wear behavior of 45CrNi pair under dry sliding condition.
利用销盘摩擦磨损试验机,考察了干滑动摩擦条件下滑动速度、接触压力对45CrNi摩擦副摩擦磨损性能的影响。
3.
The progressive cavity pump(PCP) distortions,forces and contacting instance of different pressure with the finite element analysis method are analyzed,the PCP two-dimension finite element model is constituted,the stress distributing correspond to the PCP stator rubber and the contacting pressure of the stator and rotor are obtained in this paper.
用有限元方法对螺杆泵在不同压力作用下的变形、受力及接触情况进行了分析研究,建立了螺杆泵的二维有限元模型,得出了在相应情况下螺杆泵定子橡胶的应力分布和螺杆泵定子与转子的接触压力。
4)  contact flattening
接触压扁
1.
FEM fitting of contact flattening equation of working rolls in cold strip steel rolling;
有限元法修正冷轧带钢工作辊接触压扁公式
5)  contact pressure
接触压强
1.
Pushing of the shaft for the contact pressure profile and the influence of the relative position of the hydraulically assembled shaft and sleeve are stressed and considered in the calculations.
介绍了用有限元法计算盘磨机轴的接触压强，所得数值及分布规律是可靠的；并讨论了轴压入量与直径过盈量及配合长度的关系。
2.
An uneven contact pressure between the wire and pad is indicated,which explains the welding formation in experi.
本文采用弹塑性、大变形的非线性有限元方法,模拟了超声波线焊的过程,分析了接触界面的接触压强分布,发现不均匀的接触压强分布是导致这种焊点形态的主要原因。
3.
The distribution law of contact pressure between flange and gasket is presented.
采用接触有限元方法,计算了螺栓、法兰和垫片三者之间的相互作用,给出了法兰和垫片间接触压强的分布规律,指出了考虑法兰接头密封时管道内压是一个不可忽略的计算因素,验证了螺栓之间的区域为密封的薄弱环节。
6)  Hertzian contact
赫兹触压
1.
Methods Hertzian contact technique with WC spheres was used to investigate the response of feldspathic dental porcelain to cyclic fatigue.
目的比较两种最大载荷值下牙科脆性陶瓷赫兹触压循环疲劳损伤模式。
参考词条
补充资料：触变性醇酸树脂
分子式：
CAS号：

性质：指用醇酸树脂与聚酰胺反应，制成具有触变性的改性醇酸树脂。该树脂的制法有熔融法和溶剂法两种。以其作漆料得到的触变性涂料在漆刷上不滴落；在垂直面上施工不流挂；颜料悬浮性好；刷涂性好；可厚涂层施工，遮盖力高。触变性醇酸树脂的用途主要有两种：(1)当作漆料制成触变性漆；(2)作为其他漆的改性剂，增加在罐内的表观黏度，防止颜料沉底，改进施工性。

说明：补充资料仅用于学习参考，请勿用于其它任何用途。