Calculation of contact pressure on TM and VAMACE premium connection casing couplings;

The effect of articular step-off and neniscectomy on joint alignment and contact pressures for fractures of the lateral tibial plateau;

Single chip microcomputer-based inspection of catenaries-pantograph contact pressure;

Research on contacting pressure in ball-spinning;

A pin-on-disk test rig was used to investigate the influence of sliding speed and contacting pressure on the friction and wear behavior of 45CrNi pair under dry sliding condition.

The progressive cavity pump(PCP) distortions,forces and contacting instance of different pressure with the finite element analysis method are analyzed,the PCP two-dimension finite element model is constituted,the stress distributing correspond to the PCP stator rubber and the contacting pressure of the stator and rotor are obtained in this paper.

The finite element model for contact analysis between roller and tyre under oblique contact status was established,the 3D contact finite element modeling program between roller and tyre under mixed coordinate was developed.

The character of the oblique contact model between kiln roller and tyre was studied,the build-up procedure of oblique contact model between kiln roller and tyre was developed,which is apt to the finite element analysis of roller and tyre under the condition of any load,load rate,oblique angle.

By analyzing the effects of touch voltage and equipotential bonding on low voltage distribution system,makes clear the importance and necessity of equipotential bonding on design and construction.

To equalize the potential and decrease touch voltage and step voltage on the earth s surface, an optimum design of grounding systems is proposed in this paper.

When the thickness of the low resistivity soil layer increases from the top of the grounding grid to the bottom of the grounding grid, the grounding resistance will increase dramatically and the touch voltage quickly decrease.