1) wear volume loss
体积磨损量
1.
The contact resistance and wear volume loss of the composites in the electrical sliding wear were investigated, and the worn surfaces were observed by SEM as well.
实验结果表明:在电流密度从5A/cm2增加到15A/cm2的过程中,复合材料接触电阻下降,体积磨损量增加,并且由于电弧侵蚀作用的影响,正刷的磨损量大于负刷,碳纳米管的特殊的基体增强作用及一定的导电导热能力使得CNTs-Ag-MoS2-G复合材料磨损量小于Ag-MoS2-G复合材料磨损量。
2) wear volume
磨损体积
1.
The relationships between the amounts of graphite addition and graphite eutectoid,voltage and graphite eutectoid amount,graphite addition amount and microhardness,and graphite addition amount and wear volume were discussed.
采用电刷镀技术制备了N i-石墨颗粒复合镀层,给出了N i-石墨复合电刷镀的工艺流程和镀液配方,讨论了石墨添加量与石墨共析量、电压与石墨共析量、石墨添加量与显微硬度、石墨添加量与磨损体积之间的关系。
2.
The effects of normal load,vibration amplitude and frequency on friction coefficient and wear volume were analyzed.
利用微动磨损试验机研究7A52铝合金的微动磨损行为,分析不同载荷、振幅、循环次数等参数对摩擦因数和磨损体积的影响,观察分析不同振幅下的磨痕形貌,检测磨痕微区及磨粒的成分组成,探讨其磨损机制。
3) measurement and calculation of wear volume
磨损体积的测量与计算
4) Volume erosion rate
体积磨损率
5) volume wear
体积磨耗量
6) wear cumulation
磨损累积
1.
With theoretical analysis and experimental research, the regularity of wear cumulation of carbide tools under varying cutting speed conditions is studied .
通过理论分析和试验研究,探讨硬质合金刀具在变速切削条件下磨损累积的规律。
补充资料：炭黑颗粒磨损量
分子式：
CAS号：
性质：用以表征造粒炭黑在运输过程中颗粒破碎和磨损的情况。将造粒炭黑放入规定筛子上部，经振筛后除去细粉量，再继续振筛，以测定颗粒破碎或磨损的量，其结果以质量百分数表示。
CAS号：
性质：用以表征造粒炭黑在运输过程中颗粒破碎和磨损的情况。将造粒炭黑放入规定筛子上部，经振筛后除去细粉量，再继续振筛，以测定颗粒破碎或磨损的量，其结果以质量百分数表示。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条