1) Stress of the tooth hard tissue
硬组织应力值
2) Soft tissue Wits
硬组织Wits值
3) structure stress
组织应力
1.
According to cause analysis of quench strain on die & mould,the main cause was put for heat stress,structure stress,phase transformation strain and so on .
通过模具淬火变形原因分析,可知变形主要由热应力、组织应力与相变变形所致。
4) tissue stress
组织应力
1.
On some conditions, quenched in oil, tissue stress ha.
在一定条件下,在油中淬火,组织应力对淬火应力分布的影响要远大于热应力的影响,最终试样的淬火残余应力将以表层为拉应力而心部为压应力的组织应力形式存在。
5) Structural stress
组织应力
1.
The structural stress is the main factor of deformation for 40Cr steel workpiece.
金属工件经热处理后变形是不可避免的,影响变形的因素很多,由40Cr钢制成的较小工件其变形是以组织应力为主。
2.
The research results show that the heat stress leads to the break of Fe2B and the structural stress leads to the split on the surgace of the bonding layer.
研究结果表明：热应力引起Ｆｅ２Ｂ折断，组织应力主要引起渗硼层表面开裂。
6) Ratio between Soft and Hard TissuD
软硬组织比值
补充资料：轧辊残余应力(见轧辊应力)
轧辊残余应力(见轧辊应力)
residual stresses in roll
zhagun eanyu yingli轧辊残余应力(residual stresses in roll)见礼辐应力。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条