1) Large Current Transformer (LCT)
大电流互感器
2) three phase large curr ent transformers
三相大电流互感器
3) heavy current
大电流
1.
Study of Sensor Theory Centered on Rogowski Coil for Heavy Current Measurement Application;
基于Rogowski线圈的大电流测量传感理论研究与实践
2.
Carried out the overlap power supply to the different volume cell, it was first put forward in aluminium electrolytic profession in our country, particalarly, application of heavy current silicon controlled rectifier and diode group for overlap power supply heavy current.
实行对不同容量电解槽进行叠加供电,在我国有色系统铝电解行业属首例,特别是大电流可控硅机组与二极管机组进行大电流叠加供电在国内尚属首创。
3.
The finite element analysis software,ANSYS,was used to simulate the 3D eddy current field of heavy current three-phase bus bar bridge through edge finite element method.
应用大型有限元分析软件AN SYS,采用棱边有限元方法,对大电流母线桥进行了三维涡流场的计算,得到了磁感应强度和电磁力的大小及其在母线桥中的分布规律;通过与母线桥正常运行时的实测数据对比,验证了计算模型的有效性和计算结果的可靠性,并在此基础上研究了不同工作电流、母线相间距离对磁感应强度和电磁力的影响。
4) large current
大电流
1.
By using the method of degrading and breaking the macromolecular long chains of organic substance with plasma arc produced by high voltage and large current pulse,the effect factors in breaking benzene loop and aroma hydrocarbon in waste water were studied.
采用高压大电流脉冲产生等离子弧降解破碎大分子有机物长链的方法,研究了高压脉冲放电法降解破碎工业废水中苯环、芳香烃的影响因素。
2.
There exists current distribution unevenness in large current switch apparatus parallel branch.
大电流开关电器的并联支路中存在电流分配不均匀性。
3.
In order to simulate different short-circuit faults,large current will be required in the especial test.
低压电器试验站为模拟各种短路故障,需要大电流进行试验。
5) High current
大电流
1.
Study on topology and control method of switching power supply circuit with low voltage and high current;
低电压大电流开关电源电路拓扑和控制方法研究
2.
The text describes the R&D process for 2CZ234 high current,small package rectifier module.
阐述了2CZ234型大电流小封装整流组件的研制过程。
3.
The influences of SEI and electrolyte conductance was investigated when lithium ion battery was discharged in high current.
研究了锂离子电池大电流放电性能。
6) amplifying circuit
放大电路
1.
Small-signal pre-amplifying circuit for microwave-induced thermoacoustic tomography;
微波热声成像弱信号预放大电路
2.
The paper introduces a new kind of AC AC amplifying circuit for ultrasonic vibration cutting.
本文介绍一个用于超声振动切削的新型ＡＣ－ＡＣ放大电路。
3.
Basic amplifying circuit is one of teaching emphases and difficulties in Analog Electronic Technology course as well as the theoretic foundation of the follow-up courses.
在《模拟电子技术》的课程教学中,基本放大电路是教学的重点和难点之一,更是课程后续内容学习的基础。
参考词条
补充资料：电流互感器
见互感器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。