1) reciprocation
往复性
2) reciprocating
往复
1.
Superadiabatic combustion with reciprocating flow in a porous medium has been investigated through numerical calculations.
研究多孔介质内往复流动下的超绝热燃烧。
3) to-and-fro
往复
1.
Special designed drive outfit and PLC are adopted to control object moving to-and-fro and rotating at prearranged positions.
采用特殊设计的传动机构结合PLC控制物体作直线往复运动和在预定位置作自转运动。
4) reciprocating extrusion
往复挤压
1.
Structure refinement and mechanical properties of Mg-4Al-2Si Mg alloy by reciprocating extrusion;
往复挤压Mg-4Al-2Si镁合金的组织细化与力学性能
2.
Microstructure and ageing behavior of Mg_2Si/Mg-Al composites produced by reciprocating extrusion;
往复挤压制备Mg_2Si/Mg-Al复合材料组织及时效行为研究
3.
Microstructure of bulk Mg_(92.5)Zn_(6.4)Y_(1.1) magnesium alloy prepared by reciprocating extrusion from rapidly solidified ribbons;
往复挤压快速凝固Mg_(92.5)Zn_(6.4)Y_(1.1)镁合金及其微观结构
5) reciprocating extrusion (RE)
往复挤压
1.
6%Zr were prepared by a combination of processes of rapid solidification (RS), reciprocating extrusion (RE) and extrusion (EX).
通过快速凝固(RS)、往复挤压(RE)、单次挤压(EX)工艺制备RE-EX-RS-ZK60和RE-EX-RS-66合金。
6) reciprocate screw
往复螺杆
1.
In order to solve the problem of low yield of spindle yarn on the winding machine,analysis finds out the main cause is due to the unstable quality of the key element,the reciprocate screw.
为了解决绕丝机绕成扁丝纱锭合格率低的问题,分析发现其原因是绕丝头关键零件——往复螺杆的质量难以保证,提出将传统的以45结构钢制造整体往复螺杆的工艺,改为将其滑线部分做成以尼龙1010为基体,中心轴仍为45结构钢的加工工艺,克服了原用材料加工难,精度难保证问题,同时,提出结合调整绕丝张力也可以达到提高纱锭卷绕紧度的要求。
参考词条
补充资料：连续性与非连续性(见间断性与不间断性)
连续性与非连续性(见间断性与不间断性)
continuity and discontinuity
11an父ux泊g四f“山。麻以角g、.连续性与非连续性(c。nt，n琳t:nuity一)_见间断性与不间断性。and diseo红ti-
说明：补充资料仅用于学习参考，请勿用于其它任何用途。