1)  tangent linear model
切向线性模式
1.
The two analytic examples show that: if the heating and moistening due to convection at the switch-on point is much smaller than all the other terms in the tendency equation, then keeping the "on-off " switches the same as the basic state will produce the right tangent linear model and adjoint model.
两个解析的例子表明:只要“开关”处的对流引起的加热和加湿远小于倾向方程的其它项,则保持“开关”变量与基态一致,能够正确得到切向线性模式和伴随模式。
2)  direction of the tangent
切向
1.
Put forword the determine a method on the direction of the tangent and the radius of the curvature.
指出了在自然坐标系中应用动力学方程解题的问题所在,提出了自然坐标系中切向及曲率半径的确定方法,并通过例题,说明理论的应用。
3)  single tangent
单切向
1.
Study on single tangent ring bar sprayed bubbling gas distributing desulphurization device;
单切向环栅式喷射鼓泡进气脱硫装置的研究
4)  tangential stress
切向应力
1.
Based on the Inglis formula, which calculates the tangential stress of the surrounding rock of geological stress field in different circumstances, programme is developed to compute the corresponding tangential stress of the surrounding rock of several underground plants, for instance, Ertan project of Sichuan according to different directions of longitudinal axle.
从地下洞室周边切向应力的英格里(Inglis)公式出发,提出针对不同环境的地应力场进行地下厂房纵轴线方位优选的简便方法,并编程计算了四川二滩等多个地下厂房不同纵轴线方向所对应的洞室周边切向应力,分析不同纵轴线方向条件下洞室周边切向应力的极值,并与实际工程所选取的纵轴线方向所对应的切向应力值比较,讨论了工程所选纵轴线的合理性以及洞室周边应力的集中程度。
2.
The compulation formulas on radial stress,tangential stress and deflection were derived.
运用平板理论 ,分析了周边固定受同心环形线载荷作用环形圆板的应力 ,并且导出径向应力、切向应力及挠度的计算公式 ,为结构设计提供了方
3.
The calculation formulae of normal stress difference,tangential stress and moment acted on the inner cylinder for the flow of power-law fluid in annulus with the inner cylinder executing a planetary motion under motive bipolar coordinate system were given.
给出了运动双极坐标系下幂律流体在内管做行星运动的环空中流动时流体作用在内管外壁上的法向应力差、切向应力和扭矩的计算公式;以可视为幂律流体的CMC水溶液为例,利用幂律流体在内管做行星运动的环空中流动的流函数分布的数值解对该流动时流体作用在内管壁的法向应力差、切向应力和扭矩进行了数值计算,并分析了内管自转和公转速度、环空偏心度以及压力梯度对其的影响;还以水为例,把利用数值解绘制的法向应力差、切向应力和扭矩的分布曲线与解析解绘制的法向应力差、切向应力和转矩的分布曲线进行了对比,两者吻合较好,说明给出的幂律流体在内管做行星运动的环空中流动时流体作用在内管外壁上的法向应力差、切向应力和扭矩的计算公式以及数值计算方法是正确的。
5)  tangential influx
切向入流
1.
Effect of circle tangential influx on membrane distillation flux;
旋转切向入流对膜蒸馏通量的影响
6)  tangential strain
切向应变
1.
The approximate formula of the changing value of wall thickness of the inner and outer side of the tube and the formula of the tangential strain are presented,which may be applied to practical production after amending.
通过大量管材弯曲试验,分析了沿弯曲线的切向和管壁厚方向的应力应变状态,给出弯管内、外侧管壁厚变化量和切向应变的近似计算公式。
2.
It was found that during the no_mandrel bending forming process of minor diameter tube,the actual tangential strain along pipeline direction was approximately distributed in parabola,and the maximum strain appeared around the intermediate section of the bending angle.
作为管材弯曲变形机理实验研究的一部分,通过大量实验结果证明了小直径管无芯弯曲成形过程中,沿管线方向的真实切向应变近似呈抛物线形分布,最大应变产生在弯曲角中部附近。
参考词条
补充资料:植物命名的模式和模式标本
    科或科级以下的分类群的名称,都是由命名模式来决定的。但更高等级(科级以上)分类群的名称,只有当其名称是基于属名的也是 由命名模式来决定的。种或种级以下的分类群的命名必须有模式标本根据。模式标本必须要永久保存,不能是活植物。模式标本有下列几种:
    (1)主模式标本(全模式标本、正模式标本)(holotype)是由命名人指定的模式标本,即著者发表新分类群时据以命名、描述和绘图的那一份标本。
    (2)等模式标本(同号模式标本、复模式标本)(isotype)系与主模式标本同为一采集者在同一地点与时间所采集的同号复份标本。
    (3)合模式标本(等值模式标本)(syntype)著者在发表一分类群时未曾指定主模式而引证了2个以上的标本或被著者指定为模式的标本,其数目在2个以上时,此等标本中的任何1份,均可称为合模式标本。
    (4)后选模式标本(选定模式标本)(lectotype)当发表新分类群时,著作未曾指定主模式标本或主模式已遗失或损坏时,是后来的作者根据原始资料,在等模式或依次从合模式、副模式、新模式和原产地模式标本中,选定1份作为命名模式的标本,即为后选模式标本。
    (5)副模式标本(同举模式标本)(paratype)对于某一分类群,著者在原描述中除主模式、等模式或合模式标本以外同时引证的标本,称为副模式标本。
    (6)新模式标本(neotype)当主模式、等模式、合模式、副模式标本均有错误、损坏或遗失时,根据原始资料从其他标本中重新选定出来充当命名模式的标本。
    (7)原产地模式标本(topotype)当不能获得某种植物的模式标本时,便从该植物的模式标本产地采到同种植物的标本,与原始资料核对,完全符合者以代替模式标本,称为原产地模式标本。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。