1) tangential velocity
切向速度
1.
This paper develops a new theoretical model based on the mathematical model of the tangential velocity.
本文以旋风分离器切向速度模型为基础,给出了各部分压力损失的计算方法,并针对不同的旋风分离器模型,将其计算结果与实验结果及其他的压力损失理论模型进行了比较,结果表明该计算方法可行。
2.
The numerical simulation values of axial velocity and tangential velocity are very approach to the experimental result.
其中,轴向速度和切向速度的数值模拟结果和实际测量结果非常接近;在器壁附近的外自由涡区,切向速度的数值计算与实际测量数值基本一致。
3.
The experimental results of the axal velocity and the tangential velocity in combustor have been given.
给出了燃烧室内的轴向速度和切向速度的试验结果。
2) tangential acceleration
切向加速度
1.
In this paper,the derivation and resolution of vector are used to study the introduction of the normal and tangential acceleration about circular motion, which is relatively direct-viewlng and can be easily understood by studcnts compared with the vector-triangle and differential geometry method.
本文利用导数及矢量分解方法，研究了质点作圆周运动法向和切向加速度之引入方法。
3) tangential velocity of material
物料切向速度
1.
Influence of tangential velocity of material on separation performance in the process of threeproduct HM cyclone with un-pressurized feeding;
无压给料三产品重介质旋流器内物料切向速度对分选效果的影响
4) tangential velocity distribution
切向速度分布
1.
Investigations show that there are both potential flow zone and plane circular flow zone in the tangential velocity distribution (TVD) of an ideal cyclone.
理论分析与试验研究表明，旋风筒的切向速度分布不出现势流区，主要呈现平面圆旋流分布趋势，对干燥粘性膏状物料特别有效。
5) tangential velocity superposition
切向速度迭加
6) side-cutting rate
侧向切削速度
补充资料：恒星的视向速度
见恒星的空间运动。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条