1)  Mahalanobis-Taguchi System
马氏田口
1.
Mahalanobis-Taguchi System (MYS) is a new method for studyingmultidimensional system, and it can be used to measure the degree of abnormality byconstructing and optimizing the measurement scale.
马氏田口是研究多元系统的一种新方法,它通过建立与优化测量表,测量观测值的异常程度,并进而采取相应的有效措施。
2)  Mahalanobis-Taguchi System
马氏田口方法
1.
Mahalanobis-Taguchi System(MYS) is a new method for studying multidimensional systems.
马氏田口方法是研究多元系统的一种新方法,主要用于建立和优化多元系统的测量表,以便采用优化后的测量表进行诊断/预测。
3)  Marshall
马氏
1.
Relationship between Beat numbers of Marshall and Volumetric Properties;
马氏击实次数与体积特性的关系
4)  martensite
马氏体
1.
Effect of deformation on the temper process of lath martensite;
形变对板条马氏体回火组织的影响
2.
Cold rolling deformation and recrystallization behavior of martensite Ni_(40.5)Co_(32.5)Al_(27) alloy;
Ni_(40.5)Co_(32.5)Al_(27)马氏体合金的冷变形和再结晶行为
3.
Influence of heat treatment on the properties of the heat-resistance martensite stainless steel 0Cr_(17)Ni_4Cu_4Nb;
热处理对耐热马氏体不锈钢0Cr_(17)Ni_4Cu_4Nb性能的影响
5)  markov chain
马氏链
1.
Technique to Determine the Convergence of Software Quality Based on the Broad-Balanced Markov Chain Model;
基于宽平稳马氏链的软件质量收敛性判定技术
2.
Random permutation graphs and related Markov chains;
随机置换图与马氏链的联系
3.
Aiming at the complex problem of evaluating tactical missile combat effectiveness in attacking single target,the markov chain decision models for tactical missile combat effectiveness in the way of shooting independently is put forward on the basis of markov theory,and different shooting conditions are considered,the corresponding markov chain models are established.
针对多发导弹攻击单个坚固目标时毁伤效能分析与评估这一复杂问题,运用马尔可夫过程理论建立了独立连射方式下多发战术导弹射击效能分析的马氏链模型。
6)  martensitic steel
马氏体钢
1.
The microstructure and mechanical properties of China low activation martensitic steel;
低活化马氏体钢的微观结构与力学性能
2.
Introduces forging technology and matters needing attention of valve of martensitic steel 4Cr 10 Si 2Mo, analyses the reason that the steel can ’t be cooled by air, compares forging characteristics with valve of austenitic steel 4Cr 14 Ni 14 W 2Mo and come to the feasiblity of new technology of valve adopting direct extrusion.
介绍了马氏体钢4Cr10Si2Mo气阀的锻造工艺及生产中的注意事项,分析了这种钢不能采用空冷的原因,并且与奥氏体钢4Cr14Ni14W2Mo气阀的锻造特点进行了比较,提出了气阀生产新工艺———正挤压的可行性。
3.
n this research, the characteristic of martensitic steel in abrasion was investigated by using three different test methods.
98%4种合碳量马氏体钢的磨料磨损特性进行了考察。
参考词条
补充资料:马口柴
1.明代宫中膳房所用之柴,其柴四尺许,两端刻两口,以绳缚之,故称。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。