1) flaw height
缺陷高度
1.
The article discusses the importance of the model of flaw height measuring in the NDT, and summarizes the domestic and international tendency of present relevant subjects.
本文论述了缺陷高度测量在无损检测领域的重要性,针对钢焊缝X射线照相检验没有缺陷测高仪的现状,在总结和分析当前国内外相关课题的研究动向基础上,提出开发一种新型X射线照相缺陷测高仪的总体设计:该仪器以观片灯为背景光源,用笔式的传感器采集射线底片相关部位的信号,进行去噪和数字滤波处理,利用构建的缺陷测高模型和编制的软件处理模块,直接显示出缺陷高度。
3) defect depth
缺陷深度
1.
Measurement of defect depth by infrared thermal wave nondestructive evaluation based on pulsed phase;
基于脉冲位相的红外热波无损检测法测量缺陷深度
4) Defect concentration
缺陷浓度
1.
The paper has proved that when the defect production velocity and the temperature of the thermostat, the controllable parameters,are in some range, there are the defect concentration and temperature oscillate periodically with time-the time dissipative str.
采用线性化处理、拓扑映射及数值计算相结合的方法,求解了离子辐照下各向同性晶体薄片中缺陷浓度和温度满足的非线性微分方程组,证明了当可控参量,即缺陷产生速度和恒温箱温度处于某些范围时。
2.
The results of positron annihilation spectra showed that defect concentration was different in all the DLC films.
对在不同极板负偏压下采用射频-直流等离子体方法制备得到的类金刚石膜(a-C:H)的微结构进行了测量,利用慢正电子束实验装置,探测并分析了样品缺陷浓度的分布情况。
5) defect length
缺陷长度
1.
To modify NSC,a new formula of ultimate bending moment with consideration of defect length was established.
评定含缺陷管抗弯曲特性的NSC方法(net-section collapse criterion),所给出的极限弯矩与缺陷长度无关,与实际不符。
6) degree of flaws and defects
缺陷度
1.
To indicate the degree of flaws and defects,the SAXS intensity can be used as astructure parameter of drawn fibers,it is more effective than the.
本文在用传统表征方法相比较的基础上提出了可用小角 X 射线散射(SAXS)强度来衡量纤维中的缺陷度,而缺陷度能很好地表征纤维在整个拉伸过程中力学性能的变化规律。
补充资料:点缺陷(见晶体缺陷)
点缺陷(见晶体缺陷)
point defect
点缺陷point defeet见晶体缺陷。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条