1)  posting
限载
2)  limit load
极限载荷
1.
Analysis and experiments on the plastic limit load of elbows under in-plane closing bending moments;
平面闭合弯矩作用下弯管塑性极限载荷分析与试验
2.
Analysis and experiments on the plastic limit load of elbows with local thinned area in extrados under in-plane closing bending moment;
平面闭合弯矩作用下外拱局部减薄弯管塑性极限载荷
3.
The limit loads and safety assessment of the pipe with LAT.;
含局部减薄缺陷管道的极限载荷与安全评定
3)  ultimate load
极限载荷
1.
In this paper, Mohr yield criterion is used to analyze the ultimate load of a strength - differential wedge with the vertical uniformly distributed load on an edge.
利用莫尔屈服准则,对一侧承受均布垂直载荷作用的拉压异性材料楔体进行了极限载荷分析。
2.
Based on the primal definition of ultimate state and finite element method,more accurate results of ultimate load were obtained.
而后根据极限状态的原始定义 ,利用有限元法求出极限载荷的精确结果 。
3.
The ultimate load and collapse procedure of two computational models of the structure are given.
本文对渤海八号桩基导管架平台进行了非线性倒塌的分析，分别给出了导管架平台八倍固支计算模型和考虑桩土非线性计算模型的结构倒塌极限载荷及倒塌破坏过
4)  limited load
极限载荷
1.
With oil wells being deeper and deeper,the accurate determination of the limited load-bearing capacity become more and more important.
为确定卡瓦内管柱的承载能力 ,在分析美国 API及前苏联推荐公式的基础上 ,提出力学模型 ,并根据圆柱壳弯矩理论 ,用分析和求极值方法 ,找出了卡瓦内管柱的危险截面 ,得出了简单实用的卡瓦内悬挂管柱极限载荷计算公式 ,通过实例证明了该公式的准确性 。
2.
A method for analysing the limited load of superstable truss by FEM is presented,the truss is anulysed by use of one dimensial incremental elasto plastic FEM,and optimal calculate the load incremental factor as the truss being loaded by limited load,thus the limited load of the superstable truss under various loading can be gained.
提出一种超静定桁架极限载荷的分析方法。
3.
When the actual load exceeds the limited load, the stress point is unable to move back to the yield field, which makes iteration diverge.
提出一种在确定结构极限载荷时增量弹塑性有限元法中载荷增量步长的优化分析方法。
5)  limiting load standard
限载标准
1.
Vehicle s overload and limiting load standard for bridge safety;
桥梁超重荷载与限载标准的确定
6)  collapse load
极限载荷
1.
A through-wall circumferential crack in an elbow subjected to in-plane bending moment can significantly reduce its collapse load.
含环向贯穿裂纹的弯管在受平面弯矩时明显地降低了其极限载荷,因此对含裂纹弯管的极限载荷研究是很有必要的。
2.
Results show that both reinforcing ring and reinforcing pipe can enhance the collapse load of the vessel to a great degree,and the performance of reinforcing pipe is even better than that of the reinforcing ring.
满足等面积补强法对圆柱壳开孔的要求,分别确定圆柱壳开孔未补强、采用补强圈补强和采用厚壁接管补强的三个压力容器模型,使用ANSYS软件求出三个模型的极限载荷。
参考词条
补充资料：载欢载笑
1.形容尽情地欢笑。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。