1) progressive reasoning
级进推理
2) level improving
级进
1.
During the course of the reception of aesthetism,the level improving still exists,that is,from the original aesthetic standards to rational knowledge till to the distillation of rational knowledge.
在审美接受过程中 ,始终存在着级进 ,即从初始审美观到理论认识直至理性认识的升
3) progressive die
级进模
1.
Design of multi-position progressive die for contact-plug parts;
接插件多工位级进模设计
2.
Optimization design of progressive die for BG1 sheet component;
BG1镶片级进模优化设计
3.
Development of progressive die for the right tube plate of evaporator;
蒸发器右管板级进模设计
4) progressive die
级进模具
1.
Design of high-speed precision progressive die for G2 grid;
G2膜片高速连续级进模具设计
2.
Sharing progressive die design for homogeneous plural pinouts punching;
形状近似的多件引线插脚级进模具设计
5) step feed
分级进给
1.
After the modification of step feed mechanism of deep drill combined machine tool,simplifying structure,convenient adjustment and reducing fault rate have been proved.
对深孔钻屑组合机床分级进给机构进行改进后,达到了简化结构、方便调整、减少故障的目的。
6) progressive dies
级进模
1.
The characteristics of blanking cutting-edge design on progressive dies are analysed.
分析了级进模刃口设计的特点,提出了采用交互式刃口设计的算法,给出了该算法的设计步骤和方法,并编制了相应的应用程序软件,实践证明本算法能对一般采用级进模设计的冲裁件进行工序排样设计。
2.
Use constructional type of progressive dies ,change present one step operation of single die construction for two-step blanking ,i.
用级进模结构形式,改现行简单模结构的一工步操作的冲裁为两工步操作:第一工步为半冲裁,第二工步为推料。
3.
Based on the characteristics of progressive dies structure design, a knowledge-based engineering methodology was applied into the variational progressive dies assembly design, and the method of knowledge-based progressive dies structure design in supporting top-down methodology was proposed.
针对级进模结构设计的特点,将知识工程引入变量化装配设计,提出了基于知识支持自顶向下的级进模结构设计方法;建立了一种有效的基于SolidWorks软件开发环境的级进模结构装配模型;给出了级进模结构设计的知识表示方法、模具典型组合设计与动态装配约束等关键技术。
参考词条
补充资料：演绎推理(见推理)
演绎推理(见推理)
deductive inference
住理。yanyl tullj演绎推理(deduetive infer。二ee)见
说明：补充资料仅用于学习参考，请勿用于其它任何用途。