1) Solidifying and Cooling
固化冷却
3) steam-cooling
汽化冷却
1.
The article introduces steam-cooling technology application of heating furnace.
介绍了加热炉汽化冷却技术及其应用。
2.
Introducing the necessary of medium-plate-rolling -plant heating-furnace remaking from water-cooling to steam-cooling and obvious economy benefit.
介绍了中板厂加热炉由水冷却改造为汽化冷却的必要性和明显的经济效益。
4) evaporative cooling
汽化冷却
1.
Analysis of failure causes of evaporative cooling of heating furnace and its preventive measures;
加热炉汽化冷却失效原因分析及改进措施
2.
The failure cause was analyzed which is evaporative cooling failure.
介绍了华菱集团涟源钢铁公司型材厂蓄热式加热炉的事故现象,分析了事故发生的原因是汽化冷却循环不正常。
3.
Based onthe summary ofthe skids andposts arrangement in the reheating furnace,the paper introduces the principle andcomponents of evaporative cooling system with forced recirculation and its' advantage,and give an example of successful reference for this cooling system and achieved result.
简要介绍了步进梁式加热炉炉内水梁结构布置,在此基础上论述了步进梁式加热炉强制循环汽化冷却系统的基本原理及其组成,并给出了强制循环汽化冷却在某钢厂的成功应用范例及其应用效果。
5) enhanced cooling
强化冷却
1.
In order to analyze the effect of the enhanced cooling of cutting media on the metal cutting process correctly,the contrast analysis is adopted through the experiment and simulation.
为了正确分析切削介质的强化冷却对金属切削过程的影响,采用实验和仿真对比分析的方法,探讨了不同冷却方式下试件"汽化能力"的最佳值问题。
2.
In this paper the enhanced cooling technology for the combined ramjet engine inlet of space craft was presented.
针对空天飞机组合发动机进气道的冷却要求，采用冲击－对流复合冷却技术对进气道进行强化冷却试验，按照得出的冷却结构各部分传热经验公式，用温度200K，压力1MPa低温氢作冷却剂，算出进气道的冷却热流密度，证明所用结构可以满足进气道冷却要求。
6) cool aging
冷却老化
补充资料：120固化剂
N-羟乙基乙二胺又称β-羟乙基乙二胺，俗称120固化剂，结构式H2N(CH2)2NH(CH2)2OH，分子量92．06。无色或淡黄色透明粘性液体，微有氨气味。呈强碱性。有吸湿性。与水、乙醇混溶，微溶于乙酸。能从空气中吸收二氧化碳。低毒．LD504032mg／kg。
用作环氧树脂的室温快速固化剂，参考用量16～18phr，固化条件RT／10h或80℃／3h。
贮存于阴凉、干燥的库房内，防潮。
用作环氧树脂的室温快速固化剂，参考用量16～18phr，固化条件RT／10h或80℃／3h。
贮存于阴凉、干燥的库房内，防潮。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条