1) Eccentricity Swing Transfer Mechanism
偏心转动式递纸机构
2) rotary transfer mechanism
旋转式递纸机构
1.
At present,the paper transfer mechanisms which are used widely at home and abroad include swinging gripper mechanism,rotary transfer mechanism and so on.
目前国内外胶印机所采用的递纸机构有摆动式递纸机构、旋转式递纸机构等。
3) Swinging gripper mechanism
摆动式递纸机构
1.
At present,the paper transfer mechanisms which are used widely at home and abroad include swinging gripper mechanism,rotary transfer mechanism and so on.
目前国内外胶印机所采用的递纸机构有摆动式递纸机构、旋转式递纸机构等。
4) Swing transfer mechanism
摆动式递纸机构
1.
Established fuzzy synthesis appraising model according to theory of fuzzy decision , the choice of the Law of follower motion for Swing transfer mechanism has been applied with this model .
根据模糊决策的理论,建立了模糊综合评判模型,将该模型用于选择摆动式递纸机构的运动规律,并通过具体使用要求的算例验证了该模型。
5) intermittent rotary sheet transfer mechanism
间歇旋转式递纸机构
1.
A dynamic analysis method using simulation technology for intermittent rotary sheet transfer mechanism was put forward.
提出了运用仿真技术对间歇旋转式递纸机构进行动力学分析的方法,介绍了在SIMULINK下的机构仿真过程。
6) paper-transferring mechanism swinging downward
下摆式递纸机构
补充资料：在AutoCAD中偏心圆锥与偏心圆台实体的画法
现在要画一个偏心圆锥,底面在WCS的XY平面上,圆心(0,0,0),半径100,顶点(300,0,400)在ZX平面上.
1)连接PA,PB. A(-100,0,0) B(100,0,0)
图1
在当前坐标下:
2)延长PA到C,使PA=CA;延长PB到D,使PB=DB;
3)连接CD;
4)以CD为直径画圆;
5)用XLINE命令中的二等分选项作角CPD的角平分线PO,交CD于O;
6)过O作CD的垂线,交圆于E,F;
图2
7)用三点UCS命令,取三点为:O,P,C;
8)过点O作PO的垂线GO,交PC于G;
图3
9)再次用三点UCS命令,取三点为O,F,G;
10)现在就可以画椭圆锥了!
cone-e-c-捕捉O点-捕捉F点-捕捉G点-a-捕捉P点;
图4
11)回到WCS,剖切椭圆锥
SL-选择椭圆锥-回车-XY-回车-捕捉P点.
12)删除辅助线条.
图5
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条