说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 溶胶―凝胶
1)  Sol-gel
溶胶―凝胶
2)  Sol-Gel
溶胶-凝胶
1.
Effect of pyrolysis atmosphere on properties of BLT ferroelectric films deposited by sol-gel method;
热分解气氛对溶胶-凝胶法制备BLT铁电薄膜性能的影响
2.
Chemistry Mechanism Discussion of Preparing HAP with Sol-gel Method;
溶胶-凝胶法制备羟基磷灰石粉体化学机理分析
3.
Synthesis of the blue long afterglow phosphor Sr_2MgSi_2O_7:Eu,Dy by sol-gel method and its luminescent properties;
溶胶-凝胶法合成蓝色长余辉材料Sr_2MgSi_2O_7:Eu,Dy及其发光特性
3)  sol–gel
溶胶–凝胶
1.
Titania nanoparticles were then filled into the gaps among the nanorods through an infiltration sol–gel procedure to form a composite titania film with an ordered nanostructure.
用双氧水低温氧化金属钛片的方法制备了TiO2纳米棒阵列,并以该阵列为基体,用浸渍渗透溶胶–凝胶技术制备了TiO2纳米颗粒嵌入TiO2纳米棒阵列基体的复合结构薄膜。
4)  sol-gel process
溶胶-凝胶
1.
Preparation of high temperature insulation paint by Sol-Gel process;
溶胶-凝胶法制备耐高温绝缘涂料
2.
Nanometer scale TiO2 film was prepared on glass substrate with film thickness less than 100 nm,crystal size in the range of 10~30 nm by sol-gel process combining with spin-coating technology.
以玻璃为基底,采用溶胶-凝胶法,利用旋涂技术在玻璃表面制备了膜厚小于100 nm,粒径在10~30 nm之间的纳米TiO2薄膜;利用XRD,AFM系统研究了煅烧温度及膜厚对薄膜亲水性的影响。
3.
The stable ZrO2 sol is prepared by sol-gel process with Zr(O-Bu)4 as the starting materials in this paper .
以锆酸丁酯为前驱体,采用溶胶-凝胶工艺,制备了性能稳定的ZrO_2溶胶,通过在其中添加有机粘合剂PVP和旋涂镀膜法分别制得了ZrO2薄膜和ZrO2-PVP复合薄膜。
5)  solgel ['sɔldʒel]
溶胶凝胶
1.
The activity of FCC additives of Zn(Al2O)2 with different ZnO contents were prepared by solgel,and the desulfurization effect of additives in the gasoline was evaluated in a micro reactor.
本研究以A l2O3为载体,采用溶胶凝胶法制备了不同氧化锌质量分数的液体脱硫助剂,在固定床微型反应器上对助剂。
2.
S1200 bioactive glass-ceramics were prepared by sintering the solgel derived 58S bioactive glass at 1 200 ℃, and 58S1200 glass-ceramic showed a higher bending strength and density as compared to 58S glass.
以溶胶凝胶58S生物玻璃为原料在1200℃煅烧制备了玻璃陶瓷块体。
3.
The resorcinolformaldehyde (RF) and nickel hydroxide compound aerogels were synthesized by solgel process and supercritical drying technique using resorcinol, formaldehyde, nickel nitrate and anhydrous sodium carbonate as raw materials.
以间苯二酚、甲醛、碳酸氢钠、硝酸镍为原料,采用溶胶凝胶法和超临界干燥工艺制得间苯二酚甲醛与Ni(OH)2复合气凝胶,对不同pH值和Ni(OH)2含量的复合气凝胶结构进行研究。
6)  Sol-Gel method
溶胶-凝胶
1.
Preparation of solid superacid S_2O_8~(2-)/TiO_2 by sol-gel method and its characterization;
固体超强酸S_2O_8~(2-)/TiO_2的溶胶-凝胶法制备与表征
2.
Preparation of calcium carbonate whiskers by sol-gel method
溶胶-凝胶法制备碳酸钙晶须
3.
The Al~(3+)-doped ZnO transparent conducting films ZnO∶Al(ZAO thin films) which have potential value with strongly preferred orientation of C-axis perpendicular to the substrate surface,high visible transmittance from 400—800 nm and high conductivity were prepared on glass substrates by Sol-Gel method.
结果表明,溶胶-凝胶法制备ZAO薄膜的最佳工艺条件为:溶胶浓度0。
补充资料:溶胶-凝胶法
分子式:
CAS号:

性质:一种用于制取无机固体材料和器件的方法。无机固体化合物和无机材料通常是利用高温固相反应制备,但是,一般地说,高温固相反应得到固体产物的均匀性较差,反应所需的温度较高,产物的料理论基础和形貌也无法控制。溶胶-凝胶方法利用前体物(如醇盐或无机盐)将反应物在分子的尺度上均匀混合,经溶胶和凝胶过程使之转变为固体;由于固体凝胶中反应物是在分子水平上均匀混合,避免了固相反应扩散过程,使反应可以在较低的温度下进行,还可以根据需要将凝胶成型,再经热处理得到具有一定形状的材料和器件。利用溶胶-凝胶方法可以制备出各种形态的材料,如薄膜、纤维、块体或粉末等。近年来,溶胶-凝胶方法在很多领域中得到了广泛应用,特别是在陶瓷材料和器件上制造中的应用,得到了多种均匀、具有特定微结构和性能的固体材料。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条