1) sol-gel
溶胶-胶凝
1.
Tungstophosphoric acid(TPA) supported on silica(TPA/SiO2) solid acid catalyst was prepared by sol-gel process.
采用溶胶-胶凝法制备了SiO2负载磷钨酸(TPA/SiO2)催化剂,以苯乙醛和甘油为原料合成了苯乙醛甘油缩醛,探讨了TPA/SiO2催化剂对合成反应的活性,研究了催化剂的焙烧温度、TPA负载量、反应时间、原料配比和催化剂用量对缩合反应的影响。
2) Sol-Gel
溶胶-凝胶
1.
Effect of pyrolysis atmosphere on properties of BLT ferroelectric films deposited by sol-gel method;
热分解气氛对溶胶-凝胶法制备BLT铁电薄膜性能的影响
2.
Chemistry Mechanism Discussion of Preparing HAP with Sol-gel Method;
溶胶-凝胶法制备羟基磷灰石粉体化学机理分析
3.
Synthesis of the blue long afterglow phosphor Sr_2MgSi_2O_7:Eu,Dy by sol-gel method and its luminescent properties;
溶胶-凝胶法合成蓝色长余辉材料Sr_2MgSi_2O_7:Eu,Dy及其发光特性
3) sol–gel
溶胶–凝胶
1.
Titania nanoparticles were then filled into the gaps among the nanorods through an infiltration sol–gel procedure to form a composite titania film with an ordered nanostructure.
用双氧水低温氧化金属钛片的方法制备了TiO2纳米棒阵列,并以该阵列为基体,用浸渍渗透溶胶–凝胶技术制备了TiO2纳米颗粒嵌入TiO2纳米棒阵列基体的复合结构薄膜。
4) sol-gel process
溶胶-凝胶
1.
Preparation of high temperature insulation paint by Sol-Gel process;
溶胶-凝胶法制备耐高温绝缘涂料
2.
Nanometer scale TiO2 film was prepared on glass substrate with film thickness less than 100 nm,crystal size in the range of 10~30 nm by sol-gel process combining with spin-coating technology.
以玻璃为基底,采用溶胶-凝胶法,利用旋涂技术在玻璃表面制备了膜厚小于100 nm,粒径在10~30 nm之间的纳米TiO2薄膜;利用XRD,AFM系统研究了煅烧温度及膜厚对薄膜亲水性的影响。
3.
The stable ZrO2 sol is prepared by sol-gel process with Zr(O-Bu)4 as the starting materials in this paper .
以锆酸丁酯为前驱体,采用溶胶-凝胶工艺,制备了性能稳定的ZrO_2溶胶,通过在其中添加有机粘合剂PVP和旋涂镀膜法分别制得了ZrO2薄膜和ZrO2-PVP复合薄膜。
5) solgel
['sɔldʒel]
溶胶凝胶
1.
The activity of FCC additives of Zn(Al2O)2 with different ZnO contents were prepared by solgel,and the desulfurization effect of additives in the gasoline was evaluated in a micro reactor.
本研究以A l2O3为载体,采用溶胶凝胶法制备了不同氧化锌质量分数的液体脱硫助剂,在固定床微型反应器上对助剂。
2.
S1200 bioactive glass-ceramics were prepared by sintering the solgel derived 58S bioactive glass at 1 200 ℃, and 58S1200 glass-ceramic showed a higher bending strength and density as compared to 58S glass.
以溶胶凝胶58S生物玻璃为原料在1200℃煅烧制备了玻璃陶瓷块体。
3.
The resorcinolformaldehyde (RF) and nickel hydroxide compound aerogels were synthesized by solgel process and supercritical drying technique using resorcinol, formaldehyde, nickel nitrate and anhydrous sodium carbonate as raw materials.
以间苯二酚、甲醛、碳酸氢钠、硝酸镍为原料,采用溶胶凝胶法和超临界干燥工艺制得间苯二酚甲醛与Ni(OH)2复合气凝胶,对不同pH值和Ni(OH)2含量的复合气凝胶结构进行研究。
6) Sol-Gel method
溶胶-凝胶
1.
Preparation of solid superacid S_2O_8~(2-)/TiO_2 by sol-gel method and its characterization;
固体超强酸S_2O_8~(2-)/TiO_2的溶胶-凝胶法制备与表征
2.
Preparation of calcium carbonate whiskers by sol-gel method
溶胶-凝胶法制备碳酸钙晶须
3.
The Al~(3+)-doped ZnO transparent conducting films ZnO∶Al(ZAO thin films) which have potential value with strongly preferred orientation of C-axis perpendicular to the substrate surface,high visible transmittance from 400—800 nm and high conductivity were prepared on glass substrates by Sol-Gel method.
结果表明,溶胶-凝胶法制备ZAO薄膜的最佳工艺条件为:溶胶浓度0。
补充资料:Sds-聚丙烯酰胺凝胶电泳凝胶电泳
sds-聚丙烯酰胺凝胶电泳(sds-page,sodium dodecyl sulfate-polyacrylamide gel electrohoresis)
在有去污剂十二烷基硫酸钠存在下的聚丙烯酰胺凝胶电泳。sds-page只是按照分子大小分离的,而不是根据分子所带的电荷和大小分离的。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条