1) ketone-hydrazide cross-linking
酮肼室温交联
2) ketone-hydrazide crosslinking
酮肼交联
1.
Preparation of Ketone-Hydrazide crosslinking polyurethane-(fluorinated polyacrylate) emulsions
酮肼交联型聚氨酯-氟化聚丙烯酸酯乳液的制备
2.
Fluorinated ketone-hydrazide crosslinking acrylate emulsions were prepared from dodecafluoroheptyl methacrylate,diacetone acrylamide (DAAM), adipic dihydrazides(ADH), acrylic acid, n-butyl acrylate,etc.
采用单体预乳化工艺的自由基共聚法,用甲基丙烯酸十二氟庚酯、双丙酮丙烯酰胺(DAAM)、己二酰肼(ADH)及丙烯酸、丙烯酸丁酯等制备了氟化酮肼交联聚丙烯酸酯乳液。
3) cross-linking at room temperature
室温交联
1.
In this paper first a polyacrylamide with low molecular weight was synthesized,then the polyacrylamide was hydroxymethylated with formaldehyde,finally the hydroxymethylatcd polyacrylamide and acrylamidc reacted to form the cross-linking at room temperature polyacrylamide.
首先合成低分子量的聚丙烯酰胺,再用甲醛使其羟甲基化,最后羟甲基化聚丙烯酰胺和丙烯酰胺缩合得到可室温交联的聚丙烯酰胺。
4) ambient crosslinking
室温交联
1.
The influence of three different emulsion polymerization technologies, sop-free, micro-soap and conventional emulsion polymerizations on the ambient crosslinking acrylic emulsion paints based on diacetoneacyloamide (DAAM) as crosslinking monomer and adipic hydrazine as hardener.
研究了无皂、微皂和常规三种乳液聚合工艺对以双丙酮丙烯酰胺(DAAM)为交联单体、己二酰肼为固化剂的室温交联丙烯酸乳胶漆性能的影响。
2.
No heat being needed in using, ambient crosslinking not only economizes the energy but also facilitates the application of coatings.
室温交联因其在施工中不需加热,使用方便而受到人们的重视。
5) ambient crosslinkable
室温自交联
1.
An aqueous ambient crosslinkable polymer acrylic emulsion was abtained by adding adipic acid dihydrazide(ADH) to the polyacrylate emulsion incorporating diacetone acrylamide(DAAM), and this emulsion was synthesized by seeded-emulsion polymerization.
把纳米硅溶胶与制得的室温自交联聚丙烯酸酯乳液不同比例共混,并对这些乳液及其乳胶膜的性能进行了测试。
6) room temperature cross linker
室温交联剂
1.
When the mass fraction of aziridine cross linker A was 3% in dry solid content of WPU emulsion, the water absorption of WPU pliofilm modified by different room temperature cross linker could be reduced to about 3%, and the WPU pliofilm had better permanent water resistance.
5时,制得的WPU胶膜耐水性较好;采用不同的室温交联剂对WPU进行交联改性,当w(氮丙啶型交联剂A)=3%时(相对于WPU乳液干固量而言),WPU胶膜的吸水率降低至3%左右,并具有较好的持久耐水性。
补充资料：苯肼、肼化苯、苯基联胺
CAS: 100-63-0
分子式: C6H8N2
分子量: 108.14
沸点: 238-241℃
熔点: 19-241℃
中文名称: 苯肼、肼化苯、苯基联胺
英文名称: Phenylhydrazine、Hydrazinobenzene、phenyl-Hydrazine、fenilidrazina、fenilidrazina (italian)、fenylhydrazine、phenyl-hydrazin、hydrazine-benzene、monophenylhydrazine、phenylhydrazin、phenylhydrazin
性质描述: 浅黄色油状液体。熔点19.8℃，沸点243℃（分解），相对密度1.0986（20/4℃），折光率1.6084，闪点88℃。能与醇、醚、氯仿和苯混溶，溶于稀酸，微溶于水和石油醚。
生产方法: 由苯胺经重氮化、还原、酸析得苯肼盐酸盐，再经中和制得苯肼。
用途: 该品是染料、医药、农药的中间体，用于生产色酚AS-G、药物安替比林等。将苯肼溶于95%乙醇中，然后加入苯甲醛，回流1h可得苯腙。苯腙也是有机合成中间体。苯肼也用作分析试剂。
分子式: C6H8N2
分子量: 108.14
沸点: 238-241℃
熔点: 19-241℃
中文名称: 苯肼、肼化苯、苯基联胺
英文名称: Phenylhydrazine、Hydrazinobenzene、phenyl-Hydrazine、fenilidrazina、fenilidrazina (italian)、fenylhydrazine、phenyl-hydrazin、hydrazine-benzene、monophenylhydrazine、phenylhydrazin、phenylhydrazin
性质描述: 浅黄色油状液体。熔点19.8℃，沸点243℃（分解），相对密度1.0986（20/4℃），折光率1.6084，闪点88℃。能与醇、醚、氯仿和苯混溶，溶于稀酸，微溶于水和石油醚。
生产方法: 由苯胺经重氮化、还原、酸析得苯肼盐酸盐，再经中和制得苯肼。
用途: 该品是染料、医药、农药的中间体，用于生产色酚AS-G、药物安替比林等。将苯肼溶于95%乙醇中，然后加入苯甲醛，回流1h可得苯腙。苯腙也是有机合成中间体。苯肼也用作分析试剂。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条