1) volumetric swelling degree
体积溶胀度
2) medium volume swelling
中(程度)体积溶胀
3) volume swelling
体积溶胀
4) swelling volume rati
溶胀体积比
5) Swelling degree
溶胀度
1.
It were found that the swelling degree of AC-CA membrane was higher than THF-CA membrane in ethanol,the separation effect of AC-CA membrane was better than THF-CA membrane,the tensile strength of membrane was consistent with the content of cellulose acetate,the acid base ra.
通过对膜溶胀度、拉伸强度、酸碱使用范围、分离性能的测试,发现AC-CA膜比THF-CA膜在乙醇中的溶胀度大;AC-CA膜比THF-CA膜的分离效果好。
2.
Effects of temperature and pH value on their swelling degree and swelling rate were discussed.
测定了壳聚糖、黄原胶、海藻酸钠3种天然高分子亲水性凝胶材料在竹醋液中的溶胀度。
3.
The optimum conditions for preparing the nanocomposites were determined according to the swelling degree change of samples in acetone.
根据样品在丙酮中的溶胀度,确定了纳米复合材料的最佳制备条件,在此条件下,制备了一系列蒙脱土含量不同的纳米复合材料。
6) Swelling ratio
溶胀度
1.
The mechanical properties,dehydration ratio and swelling ratio are determined.
测试了共混膜的力学性能、脱水率和溶胀度。
2.
The swelling ratios were 1 112.
13盐酸溶液、常温下的蒸馏水及8℃蒸馏水中溶胀度较大,分别为1 112。
3.
The effects of the mass ratio of polyvinyl alcohol and chitosan,the volume of acetum,the concentration of crosslinker on swelling ration are studied and optimized using orthogonal experimental method.
213 mol/L时凝胶溶胀度最大。
补充资料：体积溶胀
分子式：
CAS号：
性质：浸在一定温度溶剂中的材料因吸收溶剂而体积增大的现象，是衡量材料耐溶剂性的重要指标。对硫化胶而言，溶胀达到一定程度后体积不再增加，达到平衡溶胀。硫化胶的平衡溶胀值主要取决于橡胶的分子结构和溶剂的性质，特别是硫化胶的交联密度，因此可以由平衡溶胀值来测定硫化胶的交联密度，判定不同交联结构的分布。
CAS号：
性质：浸在一定温度溶剂中的材料因吸收溶剂而体积增大的现象，是衡量材料耐溶剂性的重要指标。对硫化胶而言，溶胀达到一定程度后体积不再增加，达到平衡溶胀。硫化胶的平衡溶胀值主要取决于橡胶的分子结构和溶剂的性质，特别是硫化胶的交联密度，因此可以由平衡溶胀值来测定硫化胶的交联密度，判定不同交联结构的分布。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条