2) time-varying mesh stiffness
时变啮合刚度
1.
The dynamic model of unsymmetric gear was proposed on the basis of mesh characteristics of involute gear transmission with unsymmetric teeth and dynamics of gears system,and the effect of time-varying mesh stiffness and static transmission error of gears system.
基于非对称渐开线圆柱齿轮传动时的啮合机理和齿轮系统动力学,同时考虑到齿轮系统时变啮合刚度和静态传递误差的影响,建立了齿轮动力学模型,利用数值积分和数值仿真方法对其进行了非线性振动研究。
2.
Dynamic model of two-stage gear system with time-varying mesh stiffness was established.
建立了考虑齿轮时变啮合刚度时的二级齿轮系统的动力学模型,用A算符方法推导出了系统的近似解析解,研究了系统对时变啮合刚度、扭矩波动及齿轮误差激励的响应。
3.
A lumped-parameter planetary gear set model is developen in the paper based on time-varying mesh stiffness which is modeled as time-varying linear spring.
建立了单级2K-H渐开线行星齿轮传动的集中质量参数型振动模型,将齿轮啮合的刚度近似等效成时变分段线性的弹簧刚度 分析了系统因时变啮合刚度激励而引起的稳态振动 得出了在2K-H渐开线行星齿轮的传动中,齿轮的动载荷与齿轮间的重合度相关;在无阻尼状态下太阳轮-行星轮的动态啮合力小于行星轮-内齿圈的啮合
3) time-varying meshing stiffness
时变啮合刚度
1.
The governing equation of a gear system with time-varying meshing stiffness is established.
建立了具有时变啮合刚度的二级齿轮系统的动力学方程式,它是一个具有时变系数的线性动力系统。
4) engagement time
啮合时间
5) time-verying stiffness mesh
时间一变刚度啮合
6) Instant meshing point
瞬时啮合点
补充资料：齿轮双面啮合检查仪
见齿轮综合检查仪。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条