1) diluted combustion
稀释燃烧
1.
The effects of preheat temperature of reactants and dilution rate of oxidizer(or oxygen concentration) on flame stability of diluted combustion,which was established in a(CH4+N2)/(Air+N2) counter flow burner,were investigated in this paper.
采用实验研究的方法探讨了反应物预热温度与稀释率两个因素对稀释燃烧火焰稳定性的影响。
2) diluted swirl non-premixed flame
稀释旋流扩散燃烧
3) moderate and intense low oxygen dilution combustion
低氧稀释混合燃烧(MILD)
4) fuel dilution
燃料稀释
5) diesel engine oil diluted by diesel oil
燃油稀释
6) lean-burn
稀薄燃烧
1.
This paper introduces the characteristic of exhausted gas from lean-burn engine and reviews the technique of purifying NO_x under lean-burn condition(especially on HC-SCR).
介绍了稀薄燃烧发动机尾气排放特点 ,并对稀薄燃烧条件下NOx 的净化技术 (尤其是HC SCR技术 )加以综述 ,最后提出建议和设想。
2.
For the LPG engine and the independent cylinder model based on the rotary coordinate system,the lean-burn control strategy using oxygen sensor was introduced.
针对LPG单燃料发动机,基于旋转坐标系的独立气缸模型,提出了一种采用λ型氧传感器的稀薄燃烧控制策略,大大降低了线性氧传感器所带来的高昂成本,并实现了燃气喷射的逐缸控制。
3.
By the experiment,the influences of engine speed,load,compression ratio,spark advance angle and spark-plug gap on lean-burn were analyzed.
通过试验分析了发动机转速、负荷、压缩比、点火提前角以及火花塞间隙对稀薄燃烧的影响,优化了稀薄技术条件下压缩比、点火提前角等参数。
补充资料：沸腾床燃烧(见流化床燃烧)
沸腾床燃烧(见流化床燃烧)
boiling-bed combustion:see fluidized-bed combustion
沸腾床燃烧(boiling一bed eombustion)见流化床燃烧。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条