1)  in-situ IR
in-situIR
1.
The dispersion of copper oxide species on γ-Al2O3 before and after CO-pretreatment was characterized by XRD, H2-TPR and in-situ IR.
采用XRD,TPR,CO吸附in-situIR,CO氧化反应等对CuO/γ-Al2O3催化剂经CO处理前后的结构、组成和催化性能进行了研究。
2)  in situ IR
原位红外
1.
The alkylation of propylene with benzene over β zeolite catalyst was studied by means of in situ IR and ion trap detector Adsorbed propylene may react with adsorbed benzene or isopropylbenzene,but it can not react with adsorbed benzene or isopropylbenzene when it is adsorbed at too strong acid site
主要采取原位红外的手段对β催化剂上苯与丙烯烷基化反应过程的机理进行了研究。
3)  in situ IR
原位红外光谱
1.
0MPa,180℃)by pressure in situ IR.
应用加压原位红外光谱技术,在6。
4)  In-situ IR
in-situ IR
5)  in situ IR
原位IR
6)  in-situ FT-IR
原位红外光谱
1.
H_2 adsorption properties of hydrogenation catalyst were studied by analyzing the in-situ FT-IR the spectra of H_2 and probe molecules adsorbed on Mo/γ-Al_2O_3 with 15% mass fraction of Mo.
利用H2与探针分子吸附的原位红外光谱技术,研究了担载Mo的质量分数为15%的Mo/-γAl2O3催化剂表面的H2吸附。
2.
The melting process of crystalline phase in PVC were investigated by in-situ FT-IR and DSC.
采用原位红外光谱 (in- situ FT- IR)法和差示扫描量热 (DSC)法研究了聚氯乙烯 (PVC)结晶区的熔融过程 ,以及淬火处理对 PVC聚集态结晶结构的影响。
参考词条
补充资料:电化学原位红外光谱法
分子式:
CAS号:

性质:红外光谱法检测灵敏度高,具有“指纹”性的谱段,对于确认电化学反应过程的中间体以及了解吸附物种的状态特别有利。但是由于信号微弱,信噪比低,特别是电化学中常用的水溶液对红外线吸收强烈,使用困难较多。直至20世纪80年代,陆续采用了一些新技术,如光学电解池的聚乙烯红外窗及1~100μm薄层电解液,红外光谱的傅里叶变换技术、偏振调制技术和扫描干涉仪等,发展了如SNIFTIRS,EMIRS,IRRAS等方法,在电化学动力学、电催化、化学电源等许多方面已获得有意义的成果。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。