1) spot welding current
点焊电流
1.
Established the intelligent monitoring model of spot welding quality of resistance whose spot welding parameter is taken as input space and whose spot welding current is taken as output space.
利用RBF网络对电阻的动态参数进行融合处理,建立了以电阻点焊参数为输入空间、点焊电流为输出空间的电阻点焊质量智能监测模型,将由多参数控制的复杂点焊过程优化为仅由点焊电流控制的过程。
2) AC spot welding
交流点焊
1.
Spectrum analysis on power signal of AC spot welding source by chopped mode;
斩波式交流点焊电源信号的频谱分析
2.
The influences of AC spot welding parameters such as welding current,electrode force and welding time etc.
研究了AZ3 1B镁合金交流点焊中焊接电流、电极压力及焊接时间等工艺参数对接头拉剪力的影响规律 ,确定了最佳工艺参数为焊接电流 170 0 0A ,电极压力 2 475N ,焊接时间为 10个周波 ,预压时间为 2 0个周波 ,该条件下接头达到最大拉剪强度为 1980N ;同时试验得出表面状态对接头性能有着显著的影
3) Reflowed solder joint
再流焊点
4) DC spot welding
直流点焊
1.
Correlations between spectrum characteristics of current waveform and nuggetsize in DC spot welding of TC4 alloy;
TC4直流点焊电流波形的频谱与熔核直径的关系
5) Multilayer spot welding with weak current
小电流多层点焊法
6) HFPEC spot welding
高频脉冲电流点焊
补充资料：标准冲击电流波形(见冲击电流发生器)
标准冲击电流波形(见冲击电流发生器)
standard impulse current wave form
blaozhun ehonglld}0n4一u box]ng标准冲击电流波形(standard impulse currentwave form)见冲击电流发生器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条