说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 抗压轴力
1)  inner resistance against compression
抗压轴力
2)  axial compressive bearing capacity
轴心抗压承载力
1.
Based on compressive test of twenty-two grouted masonry specimens and three reinforced masonry walls, the failure characteristics, the compressive strength of grouted masonry and compressive bearing capacity of reinforced masonry walls are studied, and the calculating formula of compressive strength of grouted masonry and axial compressive bearing capacity of reinforced masonry are proposed.
通过22个混凝土小砌块灌芯砌体试件及其3个配筋砌体墙片的抗压试验,研究了作为配筋砌体结构基本性能的混凝土小砌块灌芯砌体抗压破坏特征和抗压强度,并在此基础上对配筋砌体的破坏特征和轴心抗压承载力进行了研究,分别提出了混凝土小砌块灌芯砌体抗压强度和配筋砌体墙片轴心抗压承载力计算公式,并进行了试验值和公式计算值的对比分析。
3)  axial compression
轴心抗压
1.
The experiments for two specimens under axial compression were carried out to investigate the mechanical behavior of the single prefabricated hollow shear wall.
通过两个预制圆孔板剪力墙试件的轴心抗压试验,结果表明:其破坏形态为压坏,受压承载力很大,平面外位移小,不会发生失稳破坏。
4)  uniaxial compression
单轴抗压
1.
Lagrangian analysis and its application in the rock uniaxial compression;
拉格朗日分析在岩石单轴抗压中的应用
2.
The extension of cracks and the mechanic properties of rolled compacted concrete in uniaxial compression test were simulated using finite method.
采用随机骨料模型模拟碾压混凝土的细观结构,利用有限元方法数值模拟碾压混凝土试件单轴抗压的细观损伤断裂,并重点对单轴抗压强度尺寸效应进行了研究。
3.
Based on the test results,some observations were made on the concrete behavior in uniaxial compression,which included the mode of failure,the stress-strain curve,and the relationship between the stress and the volumetric strain.
5的普通混凝土,在MTS 815 flextest GT材料试验机上测试了其单轴抗压强度,其抗压强度分别达到了90。
5)  bearing resistance
承压强度,抗压力;轴承阻力
6)  axial pressure
轴向压力
1.
Plastic deformation and strengthened phenomenon of some areas of circular saw exerted axial pressure on;
圆锯片局部受轴向压力作用下的塑性变形及强化
2.
Experimental research on wave velocity under axial pressure;
轴向压力下砂岩波速的实验研究
3.
This paper carried out the analysis and testing of axial pressure distribution of V seal in theoretically and experimentally,and explored two problems in the failure and the ring number of V seal through distribution curves of the axial pressure.
文章对压裂泵液力端V形密封轴向压力分布从理论和试验两方面进行分析和测试,并由轴向压力分布曲线探讨了V形密封失效和圈数确定的问题。
补充资料:压轴
1.见"压胄子"。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条