2) defect tolerance
缺陷容限
1.
The linear inner defect tolerances corresponding to the safety graduations are stipulated in " in use pressure vessel inspection stipulation",item 36,table 3.
《在用压力容器检验规程》第36款表3规定了相应安全等级的线性埋藏缺陷容限，本文运用《CVDA—84压力容器缺陷评定规范》，对其它一切条件不变而只有应力水平发生变化时相应安全等级的缺陷容限的变化量和变化规律作初步探讨，希望对表3从强制性规定转为指导性条款起一定的参考和促进作用。
3) capacitive defect
热容缺陷
4) facial appearance
容貌缺陷
5) interior defects
内部缺陷
1.
A research on solidified structure and interior defects of quasi rimmed steel dillet in the continuous casting;
准沸腾钢连铸坯的凝固组织和内部缺陷
2.
The influences of the different division of cross section reduced ratio on the interior defects have been researched with two work steps as the same total reduction.
结果表明,两次轧制成形增加了轧件内部产生空心缺陷的危险性,损伤量的大小随变形量分配的改变不同,可以通过合理的变形量分配以避免内部缺陷的产生。
补充资料：点缺陷(见晶体缺陷)
点缺陷(见晶体缺陷)
point defect
点缺陷point defeet见晶体缺陷。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条