1) inverse push-out test
反向推出试验
1.
For this purpose,the finite element model ABAQUS is used to simulate the inverse push-out test.
为此,利用大型有限元分析软件ABAQUS来模拟反向推出试验,重点分析了混凝土强度、栓钉直径、配筋率等参数对混凝土受拉状态下栓钉性能的影响。
2) push-out test
推出试验
1.
Analysis on the behaviors of bond-slip between the shape steel and the concrete by push-out test;
型钢混凝土粘结滑移性能的推出试验及其分析(英文)
2.
The simulation analysis was carried out for shear stud push-out test by using ANSYS software.
采用有限元软件ANSYS对剪力钉推出试验进行了仿真分析,得出了与真实试验结果非常接近的荷载-滑移曲线,因而可用于实桥分析;在SAP2000软件中用弹簧单元模拟剪力钉,其刚度采用仿真推出试验所得值,对一实桥结构进行三维空间建模分析,得出在一些荷载作用下的结构响应,以比较考虑混凝土与钢箱界面滑移与否对曲线钢-混凝土箱形结合梁桥部分结构性能的影响。
3.
A series of push-out tests were conducted to study the bond mechanism, bond strength and bond-slip constitutive relations between section steel and concrete in SRC structures (steel reinforced concrete structures).
通过淹钢混凝土标准推出试验(push-outtest),对型钢混凝土粘结滑移受力机理、粘结强度和粘结滑移本构关系等关键问题进行研究。
3) reverse-test
反向试验
1.
To prove that,simple theoretical calculation for heat insulation performance of insulating case and reverse-test of temperature measurement were made.
采用物质的相变吸热原理,可以将高温环境传入保温箱的热量重新排回至高温环境,有效地提高了保温箱的抗高温能力,并对保温箱的隔热性能做了简单的理论推算和测温反向试验。
4) pull-out/push-out/push-pull cyclic/short-column test
拉拔/推出/推拉反复/短柱试验
5) static push-out test
静力推出试验
6) Pushout/pull-push cyclic/short-column test
推出/推拉反复/短柱试
补充资料：不能推出
亦称“推不出”。证明中论据和论题之间没有必然联系的逻辑错误。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条