1)  Restructuring
再结构
2)  urban reconstruction
城市再结构
1.
And railway transportation is exactly an important sector in urban reconstruction.
这一切都表明我国的城市结构目前正面临着一个重新调整的契机,而铁路交通正是城市再结构中的重要一环。
3)  recrystallization
再结晶
1.
Coupling of FEM with Monte Carlo for simulating recrystallization in cold rolling pure aluminum sheet;
有限元与Monte Carlo方法耦合的冷轧纯铝板再结晶模拟
2.
Study of recrystallization and strengthening of ODS alloys;
氧化物弥散强化合金的再结晶行为及强化机理的研究
3.
TEM study on recrystallization mechanism of IF steel;
IF钢冷轧及再结晶初期微观组织的TEM研究
4)  Re-crystallization
再结晶
1.
The results show that re-crystallization of the electrodeposited chromium layer occurs in a manner of gradient in the coating thickness direction after firing 3000 rounds.
结果显示:经3000发射击后,复合镀铬层沿着涂层厚度方向呈现梯度性再结晶,其组织由射击前的柱状晶粒团簇逐渐转变成等轴晶粒团簇,这导致镀铬层的硬度梯度分布;高收缩性铬层的表层晶粒成长最大,其相应的硬度由初始的960HV左右急剧下降到330HV左右。
2.
Lattice deformation stored energy at different cold-rolled deduces in non-electrical steels and the effect on re-crystallization texture are investigated by x-ray diffraction technique.
用X-射线衍射方法研究了不同压下率条件下冷轧无取向电工钢中各个晶体学方向的点阵畸变储能及其对再结晶织构的影响。
5)  recrystalization
再结晶
1.
Study on recrystalization of ultrafine grain copper prepared by asymmetrical accumulative roll-bonding;
大变形异步叠轧法制备超细晶铜材的再结晶研究
2.
At a given temperature, dynamical recrystalization could be postponed with the increasing of strain rate; meanwhile, at .
在相 同变形温度下,应变速率的提高可以明显推迟动态再结晶的发生:应变速率较低时,降低温 度同样可以延迟动态再结晶的发生。
3.
Behavior of recrystalization for CuZn alloy powder made by wet grind in the annealing was studied.
研究了湿磨铜锌合金粉退火过程的再结晶行为 ,实验结果表明 :湿磨铜锌合金粉具有再结晶温度低、相同温度再结晶时间短的特性。
6)  non recrystallization
未再结晶
1.
The effect of strain rate, strain amount and cooling rate in non recrystallization region on the ferrite transformation behavior and mocrostructure were studied on a Gleeble 1500 thermo methanical simulator for the low carbon pipeline steel X52.
以管线钢X5 2为研究对象 ,在Gleeble 15 0 0热模拟机上 ,进行了奥氏体未再结晶区不同形变速度、形变量和冷却速度对X5 2的相变行为及显微组织影响的研究。
2.
The effect of the reduction and the cooling rate in non recrystallization anstenite region on ferrite transformation behavior and the microstructure were studied on the Gleeble 1?500 thermomethanical simulator for the pipeline steel X52.
以管线钢X5 2为研究对象 ,在Gleeble 15 0 0热模拟机上 ,主要进行了在奥氏体未再结晶区不同形变量和冷却速度对X5 2的相变行为及显微组织影响的研究·通过光学显微镜、扫描电镜分析技术可以发现 ,随形变量和冷却速度的增加 ,晶粒明显变细·实验结果表明 ,在奥氏体未再结晶区轧制可以大大地增加铁素体的形核位置 ,使晶粒细化 ;同时冷却速度的增大 ,使铁素体的形核驱动力加大 ,形核率增加 ,也使晶粒明显细化·另外 ,与低碳钢不同的是 ,在铁素体晶粒边界和铁素体晶粒内部可以观察到有第二相的析出 ,在奥氏体未再结晶区轧制时 ,第二相的析出可以抑制再结晶 ,并且 ,析出物的存在不仅阻碍位错的运动 ,而且会造成位错的增殖·因而微合金钢细化晶粒的机理主要有 :形变诱导铁素体、铁素体的动态再结晶和第二相的析出抑制晶粒长大使晶粒细
参考词条
补充资料:(B,ψ)结构


(B,ψ)结构
(B, co)- stnicture

  (B.初结构{(B树一50.由,托;(B,毋)一。侧服珊阳】 向量丛咬或球丛等)_上的一种结构,‘它是纤维化的结构群概念的推广, 设印,:B,一召O,,为纤维化,亡为空间X上的;:维向量丛,它为映射乙x,B口。所分类.映射尔X~B认到B。的一个提升的同伦类称为否的一个(B,.沪,)结构,即它是满足尹厂七‘二著的映射了:x、B。的一个等价类,这里两个映射老‘及着‘:X一B,称为等价单(equ-ivalent)加果它们是纤维同伦的.我们无法对等价的纤维化一致地定义‘B。,甲。)结构,因为这种一致性与等价的选取有关. 设有一个纤维化件:B尸,BO,及映射g二B一Br,,的序列(B,甲妇,满足j,甲尸“叭、g,(j;二BO;卜BOI+,为标准映射).族毛B,,价,,穿r}(有时只是{B,,价r})称为一个结均序烈(s‘r“cturc series)·流形M”的法丛(no曲al bu;,dle){心r}一上(B;,巩)结构序列的一个等价类称为M的一个(B,沪)结构;它们从某个充分大的;起均相等带有固定(B,初结构的流形M”称为(B,,)苹形((B·,)一manifold). 可以研究用更一般的分类球丛空间BG、代替B以、井能在其上引进了B,树结构【补注】这里 撇。气噢诫G‘,(R叶”)是R”+r中r平面的Gras:mann流形的极限.
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。