2) bad rigidity
刚性差
1.
It is difficult to machine because of its bad rigidity and easy distortion.
薄壁半圆环形结构的零件属断续加工,由于零件的刚性差,容易变形,加工较为困难。
3) linear error
线性误差
1.
Analysis of linear error of magnetoelectric phase difference type torque rotate speed transducer;
磁电相位差式转矩转速传感器的线性误差分析
2.
The linear error compensation of the resistance respond senor with the polynomial mathematic model is investigated The mathematic compensation model is established, and the error of the simulation vale to the sample is less than 0 02% by 4 times power polynomial, the simulating precision is high The difference between calculation result and actual data is very little after compensatio
研究采用多项式补偿数学模型对应变片式传感器进行线性误差补偿。
3.
This paper introduces the programme for processing the linear error data of the torquemeter with C language,and points out that the computed result of the programme is accurate and can avoid the faults caused by the manual calculation.
介绍了用C语言编写的线性误差数据处理程序,指出该程序计算结果准确,可避免人工计算造成的失误。
4) Error Character
误差特性
1.
Based on the error state equation of strapdown inertial navigation system,the dynamic and static error character is investigated in this paper.
捷联惯性导航系统动静态误差特性是基于惯性的组合导航系统的主要误差来源。
5) Linearity error
线性误差
1.
Adjusting the linearity error about the balance of Sartorius by using software;
采用软件校正赛多利斯天平线性误差
2.
Radar pulse repetition intervals can be analyzed through simple serial error and linearity error function primary,minimal spanning trees is used in verdict function to extract the PRI model.
通过简单的序列误差和线性误差判决函数对雷达脉冲重频模式进行初步分析,再将聚类方法中的最小张树算法应用于判决函数中去对雷达信号的重频特征进行分析,从而得到了信号的重频模式,为雷达脉冲重频模式识别提供一种新的分析思路,仿真实验验证了算法的有效性。
6) error characteristics
误差特性
1.
The analysis shows some of its error characteristics different from those of the data measured on land,namely,independence,segmented non-normality and can be approximated by higher order auto-regressive(AR) model.
针对航天测量船船载测量设备工程背景复杂、数据产生过程复杂、误差源多的特点,采用三次等距B样条函数作为船载测量数据误差分离工具,对大量原始测量数据误差的统计特性进行检验分析,得出了船载外测数据不同于陆基测量的一些误差特性——非独立性、子段非正态性、需用高阶AR模型描述。
2.
The mathematical model of ECVT(Electronic Capacitive Voltage Transformer) in power system is established,which is used to analyze its error characteristics based on the definitions of transient-and steady-state errors.
建立电力系统中电容分压型电子式电压互感器(ECVT)电容分压器的数学模型,依据电子式电压互感器暂、稳误差的定义,提出运用ECVT电容分压器的数学模型分析ECVT误差特性的思想。
3.
Direc to the application of GPS RTK technology to line measuring the working conditions,data transmission chain,operating speed,operating methods,operating precision,the bias of the antenna phase center of the error characteristics,the base station location error,multipath errors,signal interference,weather conditions and quality control est.
针对GPS RTK技术在线路测量应用中的工作条件、数据链传输、作业速度、作业方法、作业精度,误差特性中的天线相位中心位置的偏差、基准站的位置误差、多路径误差、信号干扰、气象条件及质量控制等问题,结合测量的作业特点,提出了提高RTK作业精度若干方法,论述了RTK技术的优点与不足。
补充资料：采用刚性滑道密封的铅精矿烧结机(株洲冶炼厂)
采用刚性滑道密封的铅精矿烧结机(株洲冶炼厂)
采用刚性滑道密封的铅精矿烧结机(株洲冶炼厂)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条