1) extremal convexity
极端凸
1.
In this paper, we discusses the strong convexity, very convexity, near strong convexity, extremal convexity and (w) property, and the results generalize the corresponding results in refrence and so on.
讨论了置换空间PBPS的强凸性、非常凸性、近强凸性、极端凸性及(ω)性质,其结果推广了文献[6]等相应的结论。
2) extremely c0nvex (smooth)
极端凸(光滑)
3) Salient pole
凸极
1.
In view of transmission equipment of huge power,this text emphasizes the structure and principle of a salient pole type eddy-current dynamometer,and makes a comparison between other type dynamometers.
中小功率的涡流测功机作为模拟负载已广泛应用于旋转设备的出厂或型式试验中,针对大功率传动设备的测试,着重介绍一种凸极式涡流测功机的结构、原理,并列出与其他种类的测功机在选型上的比较。
4) salient pole
凸极，显极
5) edge cam
端面凸轮
1.
NC machining of edge cam based on Proe2001 and Cincinnati VMC-1000;
基于Proe2001和辛辛那提马刀1000的端面凸轮NC加工
6) raised head face
凸台端面
1.
This paper points out the incompleteness of the tongs for the raised head face of the crank in the small IC Engine,then an improved method is given.
小型内燃机的曲轴连杆组件大都由左右半曲轴和连杆压装而成 压装后,为使曲轴轴径磨削后达到设计要求,必须在压装前保证曲轴外凸台端面与曲轴轴径轴线的垂直度要求 以往设计和使用的凸台磨夹具存在定位和夹紧方案的不合理,本文提出了改进方案,使该组件因此道工序造成的报废率降至几乎为
补充资料：凸凸
1.高出貌。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条