1) flat wing-type
平板翼型
1.
In order to find a method to construct a wing-type air-flow measuring device with greater output differential pressure signal,steady characteristic and lower resistance loss,we installed separately a flat wing-type and a three-curved wing-type air-flow measuring devices into the inlet duct of boiler s forced draft fan of two steam power plants.
为寻求风量准确的测量方法和输出压差信号大，特性稳定且阻力损失小的机翼型风量测量装置，我们将平板翼型和三曲线翼型风量测量装置分别安装在两个电厂锅炉送风机入口风道上，进行了实际测试和分析，结果表明平板翼型风量测量装置的特性更好一些，输出压差信号大，阻力损失较小，稳定性好。
2) flat V tip vane
平板V型小翼
1.
Optimization of flat V tip vane geometry parameters were tested to upgrade power coefficient of wind turbine C_p.
为提高风力机的功率系数Cp,对平板V型小翼的参数进行了优化试验。
3) flat wing
平板翼
1.
After studying the liquid characteristics and principles of the Weis-Fogh mechanism,the equation of lifting force for a flat wing was derived,and a function for lifting force in terms of rotational angular velocity and angular acceleration was determined.
通过对Weis-Fogh机构原理与流体特性的深入研究,从理论上推导出平板翼的升力表达式,确定了升力与旋转角速度及角加速度之间的函数关系。
4) flat-plate wing
平板机翼
5) flat-plate delta wing
平板三角翼
1.
A sharp-edged flat-plate delta wing of 82.
5°具有尖削前缘的细长平板三角翼以及加上背鳍高度分别为hL/s=0。
2.
A force measurement experimental study was performed on a flat-plate delta wing of 82.
对细长体平板三角翼和加上两个不同高度背鳍后的组合体在低速风洞进行了六分量天平测力实验,三角翼后掠角82。
3.
For the flat-plate delta wing at zero sideslip, the theory is that the vortices over the wing are conical, symmetric, and stable for all angles of attack, but adding a low dorsal fin to the wing would destabilize the vortices and the vortex pair is unstable and become non-conical, or non-stationary, or asymmetric, or all of them.
该文指出平板三角翼在无侧滑、大迎角下其前缘涡在不破裂的情况下是稳定的、锥型的和对称的。
6) blade shape gauge
叶片(翼型)样板
补充资料：JP型平板式橡胶减震器
分子式：
CAS号：
性质：橡胶减震器的一种，系外形为平板状的橡胶金属制品。其结构为内外金属板(环)，中间夹橡胶，以模压法生产。可分JP-I、IP-Ⅱ及JP-III三种型号。用于无线电、仪器和仪表设备，以保护其整机免受震动和冲击的影响。
CAS号：
性质：橡胶减震器的一种，系外形为平板状的橡胶金属制品。其结构为内外金属板(环)，中间夹橡胶，以模压法生产。可分JP-I、IP-Ⅱ及JP-III三种型号。用于无线电、仪器和仪表设备，以保护其整机免受震动和冲击的影响。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条