1) mode-mismatch loss
模不匹配损耗
1.
The mode-mismatch loss is calculated to mode of the step fiber by many methods.
用多种方案计算阶跃光纤中LP01模传输的模不匹配损耗LM,证实了本方案具有很多优点,具有较好的精确性和稳定性。
2) outgoing matching loss
出局匹配损耗
3) unmatched models
模型不匹配
1.
To improve the Smith precompensation controller,a noninear method with varied dead zone is adopted in this paper,so the robust of stability about the unmatched models of the closed loop system is satisfying.
本文采用可变死区范围的非线性方法改进基本的Smith预估补偿器,使得闭环系统关于模型不匹配的稳定鲁棒性令人满意。
4) Lossless match
无耗匹配
5) Lossy matching
有耗匹配
1.
Lossy matching structure modality and HFET technique is adopted in this chip.
该芯片采用有耗匹配电路结构,利用HFET工艺制作,在3~6GHz频段内饱和输出功率达到3W,功率增益大于23dB,输入、输出驻波比均小于2。
2.
The structure of lossy matching amplifier is introduced to realize a wider frequence band.
该芯片采用有耗匹配电路结构以拓宽频带;通过三级级联放大、末级采用大栅宽器件进行功率合成,实现了电路的高增益和大功率输出;采用0。
3.
The use of lossy matching amplifier topology of the structure to carry out the actual design and using ADS on the design of amplifier simulation and optimization.
为了正确匹配,采用ADS的负载牵引法得到LD-MOS场效应晶体管MW6S004N的输入和输出阻抗值,然后使用有耗匹配式放大器的拓扑结构进行实际设计,并使用ADS对设计的放大器进行仿真和优化。
6) unmatched loss
失配损耗
1.
And the equation of the relation between unmatched loss and standing wave ratio is also derived through the analysis of measured result.
通过对水负荷射频功率测量问题的深入研究 ,详细分析了阻抗失配损耗引起的测量误差的机理 ,得到了失配损耗与工程可操作的参数——驻波比间的关系式 ,由计算机仿真出了可用于工程实践的曲线 ,并提出了一种基于一次反射的提高功率测量精度的方法。
补充资料：介质损耗角正切试验(见电容率与损耗因数试验)
介质损耗角正切试验(见电容率与损耗因数试验)
dielectric loss tangent test
)!eZh.sunhooJ一002匕engq一e sh一yon介质损耗角正切试验(dieleetri。1055 tangenttest)见电容率与损耗因数试验。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条